serial_lpuart: Fix config check issue when using clk driver in SPL
Should use CONFIG_IS_ENABLED not IS_ENABLED for CLK driver, so it will
check the CONFIG_SPL_CLK when building SPL
Signed-off-by: Ye Li <ye.li@nxp.com>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
diff --git a/drivers/serial/serial_lpuart.c b/drivers/serial/serial_lpuart.c
index 57dd4a7..4b0a964 100644
--- a/drivers/serial/serial_lpuart.c
+++ b/drivers/serial/serial_lpuart.c
@@ -106,7 +106,7 @@
return CONFIG_SYS_CLK_FREQ;
}
-#if IS_ENABLED(CONFIG_CLK)
+#if CONFIG_IS_ENABLED(CLK)
static int get_lpuart_clk_rate(struct udevice *dev, u32 *clk)
{
struct clk per_clk;
@@ -148,7 +148,7 @@
u16 sbr;
int ret;
- if (IS_ENABLED(CONFIG_CLK)) {
+ if (CONFIG_IS_ENABLED(CLK)) {
ret = get_lpuart_clk_rate(dev, &clk);
if (ret)
return;
@@ -237,7 +237,7 @@
u32 clk;
int ret;
- if (IS_ENABLED(CONFIG_CLK)) {
+ if (CONFIG_IS_ENABLED(CLK)) {
ret = get_lpuart_clk_rate(dev, &clk);
if (ret)
return;
@@ -306,7 +306,7 @@
u32 sbr;
int ret;
- if (IS_ENABLED(CONFIG_CLK)) {
+ if (CONFIG_IS_ENABLED(CLK)) {
ret = get_lpuart_clk_rate(dev, &clk);
if (ret)
return;