firmware: ti_sci_static_data: Make file board agnostic
Static DMA channel data for R5 SPL is mostly board agnostic so use SOC
configs instead of EVM specific config to ease adding new board support.
Drop J7200 EVM specific settings as its same as J721e
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Reviewed-by: Nishanth Menon <nm@ti.com>
diff --git a/drivers/firmware/ti_sci_static_data.h b/drivers/firmware/ti_sci_static_data.h
index 8529ef2..5ae0556 100644
--- a/drivers/firmware/ti_sci_static_data.h
+++ b/drivers/firmware/ti_sci_static_data.h
@@ -16,7 +16,7 @@
#if IS_ENABLED(CONFIG_K3_DM_FW)
-#if IS_ENABLED(CONFIG_TARGET_J721E_R5_EVM)
+#if IS_ENABLED(CONFIG_SOC_K3_J721E)
static struct ti_sci_resource_static_data rm_static_data[] = {
/* Free rings */
{
@@ -48,46 +48,12 @@
},
{ },
};
-#endif /* CONFIG_TARGET_J721E_R5_EVM */
+#endif /* CONFIG_SOC_K3_J721E */
-#if IS_ENABLED(CONFIG_TARGET_J7200_R5_EVM)
+#if IS_ENABLED(CONFIG_SOC_K3_J721S2)
static struct ti_sci_resource_static_data rm_static_data[] = {
/* Free rings */
{
- .dev_id = 235,
- .subtype = 1,
- .range_start = 124,
- .range_num = 32,
- },
- /* TX channels */
- {
- .dev_id = 236,
- .subtype = 13,
- .range_start = 6,
- .range_num = 2,
- },
- /* RX channels */
- {
- .dev_id = 236,
- .subtype = 10,
- .range_start = 6,
- .range_num = 2,
- },
- /* RX Free flows */
- {
- .dev_id = 236,
- .subtype = 0,
- .range_start = 60,
- .range_num = 8,
- },
- { },
-};
-#endif /* CONFIG_TARGET_J7200_R5_EVM */
-
-#if IS_ENABLED(CONFIG_TARGET_J721S2_R5_EVM)
-static struct ti_sci_resource_static_data rm_static_data[] = {
- /* Free rings */
- {
.dev_id = 272,
.subtype = 1,
.range_start = 180,
@@ -116,7 +82,7 @@
},
{ },
};
-#endif /* CONFIG_TARGET_J721S2_R5_EVM */
+#endif /* CONFIG_SOC_K3_J721S2 */
#if IS_ENABLED(CONFIG_SOC_K3_AM625)
static struct ti_sci_resource_static_data rm_static_data[] = {