nds32: Enable two banks of SDRAM on Andes board
The original adp-ag101/adp-ag101p initialize only one bank(64MB)
by default at boot time, but it is not enough for some application,
so increasing to two banks(128M).
Signed-off-by: Kuan-Yu Kuo <ken.kuoky@gmail.com>
Cc: Macpaul Lin <macpaul@gmail.com>
diff --git a/arch/nds32/cpu/n1213/ag101/lowlevel_init.S b/arch/nds32/cpu/n1213/ag101/lowlevel_init.S
index 29c93fe..55985cf 100644
--- a/arch/nds32/cpu/n1213/ag101/lowlevel_init.S
+++ b/arch/nds32/cpu/n1213/ag101/lowlevel_init.S
@@ -38,6 +38,7 @@
#define SDMC_CR1_A (CONFIG_FTSDMC021_BASE + FTSDMC021_CR1)
#define SDMC_CR2_A (CONFIG_FTSDMC021_BASE + FTSDMC021_CR2)
#define SDMC_B0_BSR_A (CONFIG_FTSDMC021_BASE + FTSDMC021_BANK0_BSR)
+#define SDMC_B1_BSR_A (CONFIG_FTSDMC021_BASE + FTSDMC021_BANK1_BSR)
#define SDMC_TP1_D CONFIG_SYS_FTSDMC021_TP1
#define SDMC_TP2_D CONFIG_SYS_FTSDMC021_TP2
@@ -45,6 +46,7 @@
#define SDMC_CR2_D CONFIG_SYS_FTSDMC021_CR2
#define SDMC_B0_BSR_D CONFIG_SYS_FTSDMC021_BANK0_BSR
+#define SDMC_B1_BSR_D CONFIG_SYS_FTSDMC021_BANK1_BSR
/*
* parameters for the static memory controller
@@ -167,12 +169,12 @@
*/
led 0x1a
write32 SDMC_B0_BSR_A, SDMC_B0_BSR_D ! 0x00001100
+ write32 SDMC_B1_BSR_A, SDMC_B1_BSR_D ! 0x00001140
/* clear empty BSR registers */
led 0x1b
li $r4, CONFIG_FTSDMC021_BASE
li $r5, 0x0
- swi $r5, [$r4 + FTSDMC021_BANK1_BSR]
swi $r5, [$r4 + FTSDMC021_BANK2_BSR]
swi $r5, [$r4 + FTSDMC021_BANK3_BSR]
@@ -223,6 +225,8 @@
* - after remap: flash/rom 0x80000000, sdram: 0x00000000
*/
led 0x1c
+ write32 SDMC_B0_BSR_A, 0x00001000
+ write32 SDMC_B1_BSR_A, 0x00001040
setbf15 AHBC_CR_A, FTAHBC020S_CR_REMAP ! 0x1
#endif /* #ifdef CONFIG_MEM_REMAP */