board: atmel: clean up peripheral clock code
Due to introducing the new peripheral clock handle functions,
use these functions to reduce duplicated code.
Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Tested-by: Heiko Schocher <hs@denx.de>
[Rebased on current master, fixup for at91rm9200ek]
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>
diff --git a/board/ronetix/pm9261/led.c b/board/ronetix/pm9261/led.c
index cc4c2a0..53e353a 100644
--- a/board/ronetix/pm9261/led.c
+++ b/board/ronetix/pm9261/led.c
@@ -9,15 +9,12 @@
#include <common.h>
#include <asm/gpio.h>
-#include <asm/arch/at91_pmc.h>
+#include <asm/arch/clk.h>
#include <asm/arch/gpio.h>
void coloured_LED_init(void)
{
- struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
-
- /* Enable clock */
- writel(1 << ATMEL_ID_PIOC, &pmc->pcer);
+ at91_periph_clk_enable(ATMEL_ID_PIOC);
gpio_direction_output(CONFIG_RED_LED, 1);
gpio_direction_output(CONFIG_GREEN_LED, 1);
diff --git a/board/ronetix/pm9261/pm9261.c b/board/ronetix/pm9261/pm9261.c
index b96f745..3cc01cb 100644
--- a/board/ronetix/pm9261/pm9261.c
+++ b/board/ronetix/pm9261/pm9261.c
@@ -14,7 +14,6 @@
#include <asm/gpio.h>
#include <asm/arch/at91sam9_smc.h>
#include <asm/arch/at91_common.h>
-#include <asm/arch/at91_pmc.h>
#include <asm/arch/at91_rstc.h>
#include <asm/arch/at91_matrix.h>
#include <asm/arch/clk.h>
@@ -41,7 +40,6 @@
unsigned long csa;
struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC;
struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;
- struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
/* Enable CS3 */
csa = readl(&matrix->csa) | AT91_MATRIX_CSA_EBI_CS3A;
@@ -69,9 +67,8 @@
AT91_SMC_MODE_TDF_CYCLE(2),
&smc->cs[3].mode);
- writel(1 << ATMEL_ID_PIOA |
- 1 << ATMEL_ID_PIOC,
- &pmc->pcer);
+ at91_periph_clk_enable(ATMEL_ID_PIOA);
+ at91_periph_clk_enable(ATMEL_ID_PIOC);
/* Configure RDY/BSY */
gpio_direction_input(CONFIG_SYS_NAND_READY_PIN);
@@ -89,7 +86,6 @@
static void pm9261_dm9000_hw_init(void)
{
struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC;
- struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
/* Configure SMC CS2 for DM9000 */
writel(AT91_SMC_SETUP_NWE(2) | AT91_SMC_SETUP_NCS_WR(0) |
@@ -110,7 +106,7 @@
&smc->cs[2].mode);
/* Configure Interrupt pin as input, no pull-up */
- writel(1 << ATMEL_ID_PIOA, &pmc->pcer);
+ at91_periph_clk_enable(ATMEL_ID_PIOA);
at91_set_pio_input(AT91_PIO_PORTA, 24, 0);
}
#endif
@@ -145,8 +141,6 @@
static void pm9261_lcd_hw_init(void)
{
- struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
-
at91_set_a_periph(AT91_PIO_PORTB, 1, 0); /* LCDHSYNC */
at91_set_a_periph(AT91_PIO_PORTB, 2, 0); /* LCDDOTCK */
at91_set_a_periph(AT91_PIO_PORTB, 3, 0); /* LCDDEN */
@@ -170,7 +164,7 @@
at91_set_b_periph(AT91_PIO_PORTB, 27, 0); /* LCDD22 */
at91_set_b_periph(AT91_PIO_PORTB, 28, 0); /* LCDD23 */
- writel(1 << 17, &pmc->scer); /* LCD controller Clock, AT91SAM9261 only */
+ at91_system_clk_enable(AT91_PMC_HCK1);
gd->fb_base = ATMEL_BASE_SRAM;
}
@@ -224,12 +218,8 @@
int board_early_init_f(void)
{
- struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
-
- /* Enable clocks for some PIOs */
- writel(1 << ATMEL_ID_PIOA |
- 1 << ATMEL_ID_PIOC,
- &pmc->pcer);
+ at91_periph_clk_enable(ATMEL_ID_PIOA);
+ at91_periph_clk_enable(ATMEL_ID_PIOC);
at91_seriald_hw_init();