tegra2: Plumb in SPI/UART switch code
On Seaboard the UART and SPI interfere with each other. This causes the UART
to receive spurious zero bytes after SPI transactions and also means that
SPI can corrupt a few output characters when it starts up if they are still
in the UART buffer.
This updates the board to use the SPI/UART switch to avoid the problem.
For now this feature is turned off since it needs changes to the NS16550
UART to operate.
Signed-off-by: Simon Glass <sjg@chromium.org>
Signed-off-by: Tom Warren <twarren@nvidia.com>
diff --git a/board/nvidia/common/board.c b/board/nvidia/common/board.c
index 6a1312c..c3f6796 100644
--- a/board/nvidia/common/board.c
+++ b/board/nvidia/common/board.c
@@ -112,9 +112,13 @@
*/
int board_init(void)
{
+ /* Do clocks and UART first so that printf() works */
clock_init();
clock_verify();
+#ifdef CONFIG_SPI_UART_SWITCH
+ gpio_config_uart();
+#endif
#ifdef CONFIG_TEGRA2_SPI
spi_init();
#endif
@@ -152,7 +156,11 @@
pin_mux_uart(uart_ids);
/* Initialize periph GPIOs */
+#ifdef CONFIG_SPI_UART_SWITCH
+ gpio_early_init_uart();
+#else
gpio_config_uart();
+#endif
return 0;
}
#endif /* EARLY_INIT */
diff --git a/board/nvidia/common/board.h b/board/nvidia/common/board.h
index 1f57086..80fdcbe 100644
--- a/board/nvidia/common/board.h
+++ b/board/nvidia/common/board.h
@@ -26,5 +26,6 @@
void gpio_config_uart(void);
int tegra2_mmc_init(int dev_index, int bus_width, int pwr_gpio, int cd_gpio);
+void gpio_early_init_uart(void);
#endif /* BOARD_H */
diff --git a/board/nvidia/seaboard/seaboard.c b/board/nvidia/seaboard/seaboard.c
index 7f2827b..0b779f6 100644
--- a/board/nvidia/seaboard/seaboard.c
+++ b/board/nvidia/seaboard/seaboard.c
@@ -31,6 +31,8 @@
#endif
#include "../common/board.h"
+/* TODO: Remove this code when the SPI switch is working */
+#ifndef CONFIG_SPI_UART_SWITCH
/*
* Routine: gpio_config_uart_seaboard
* Description: Force GPIO_PI3 low on Seaboard so UART4 works.
@@ -48,6 +50,7 @@
return;
gpio_config_uart_seaboard();
}
+#endif
#ifdef CONFIG_TEGRA2_MMC
/*