AVR32: macb - Search for PHY id
This patch adds support for searching through available PHY-addresses in
the macb-driver. This is needed for the ATEVK1100 evaluation board,
where the PHY-address will be initialized to either 1 or 7.
This patch adds a config option, CONFIG_MACB_SEARCH_PHY, which when
enabled tells the driver to search for the PHY address.
Signed-off-by: Gunnar Rangoy <gunnar@rangoy.com>
Signed-off-by: Paul Driveklepp <pauldriveklepp@gmail.com>
Signed-off-by: Olav Morken <olavmrk@gmail.com>
Signed-off-by: Ben Warren <biggerbadderben@gmail.com>
diff --git a/drivers/net/macb.c b/drivers/net/macb.c
index 98e8c73..af0409b 100644
--- a/drivers/net/macb.c
+++ b/drivers/net/macb.c
@@ -317,6 +317,30 @@
netdev->name, status);
}
+#ifdef CONFIG_MACB_SEARCH_PHY
+static int macb_phy_find(struct macb_device *macb)
+{
+ int i;
+ u16 phy_id;
+
+ /* Search for PHY... */
+ for (i = 0; i < 32; i++) {
+ macb->phy_addr = i;
+ phy_id = macb_mdio_read(macb, MII_PHYSID1);
+ if (phy_id != 0xffff) {
+ printf("%s: PHY present at %d\n", macb->netdev.name, i);
+ return 1;
+ }
+ }
+
+ /* PHY isn't up to snuff */
+ printf("%s: PHY not found", macb->netdev.name);
+
+ return 0;
+}
+#endif /* CONFIG_MACB_SEARCH_PHY */
+
+
static int macb_phy_init(struct macb_device *macb)
{
struct eth_device *netdev = &macb->netdev;
@@ -325,6 +349,13 @@
int media, speed, duplex;
int i;
+#ifdef CONFIG_MACB_SEARCH_PHY
+ /* Auto-detect phy_addr */
+ if (!macb_phy_find(macb)) {
+ return 0;
+ }
+#endif /* CONFIG_MACB_SEARCH_PHY */
+
/* Check if the PHY is up to snuff... */
phy_id = macb_mdio_read(macb, MII_PHYSID1);
if (phy_id == 0xffff) {