mmc: rockchip_sdhci: Fix HS400 mode write on RK3568
Testing has shown that writing to eMMC using HS400 modes on RK3568
result in an ERROR.
Change the tap number for transmit clock to fix this.
Also stop DLL when config_dll() is called to disable DLL.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/drivers/mmc/rockchip_sdhci.c b/drivers/mmc/rockchip_sdhci.c
index 285332d..706fb12 100644
--- a/drivers/mmc/rockchip_sdhci.c
+++ b/drivers/mmc/rockchip_sdhci.c
@@ -71,7 +71,6 @@
#define DLL_RXCLK_NO_INVERTER BIT(29)
#define DLL_RXCLK_ORI_GATE BIT(31)
#define DLL_TXCLK_TAPNUM_DEFAULT 0x10
-#define DLL_TXCLK_TAPNUM_90_DEGREES 0x9
#define DLL_TXCLK_TAPNUM_FROM_SW BIT(24)
#define DLL_TXCLK_NO_INVERTER BIT(29)
#define DLL_STRBIN_TAPNUM_DEFAULT 0x4
@@ -314,8 +313,10 @@
int val, ret;
u32 extra, txclk_tapnum;
- if (!enable)
+ if (!enable) {
+ sdhci_writel(host, 0, DWCMSHC_EMMC_DLL_CTRL);
return 0;
+ }
if (clock >= 100 * MHz) {
/* reset DLL */
@@ -648,7 +649,7 @@
.config_dll = rk3568_sdhci_config_dll,
.flags = FLAG_INVERTER_FLAG_IN_RXCLK,
.hs200_txclk_tapnum = DLL_TXCLK_TAPNUM_DEFAULT,
- .hs400_txclk_tapnum = DLL_TXCLK_TAPNUM_DEFAULT,
+ .hs400_txclk_tapnum = 0x8,
};
static const struct sdhci_data rk3588_data = {
@@ -656,7 +657,7 @@
.set_clock = rk3568_sdhci_set_clock,
.config_dll = rk3568_sdhci_config_dll,
.hs200_txclk_tapnum = DLL_TXCLK_TAPNUM_DEFAULT,
- .hs400_txclk_tapnum = DLL_TXCLK_TAPNUM_90_DEGREES,
+ .hs400_txclk_tapnum = 0x9,
};
static const struct udevice_id sdhci_ids[] = {