dm: spi: Correct status register access width
The status register on ICH9 is a single byte, so use byte access when
writing to it, to avoid updating the control register also.
Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
Reviewed-by: Jagan Teki <jteki@openedev.com>
diff --git a/drivers/spi/ich.c b/drivers/spi/ich.c
index 6b6cfbf..66a5cba 100644
--- a/drivers/spi/ich.c
+++ b/drivers/spi/ich.c
@@ -411,6 +411,7 @@
const void *dout, void *din, unsigned long flags)
{
struct udevice *bus = dev_get_parent(dev);
+ struct ich_spi_platdata *plat = dev_get_platdata(bus);
struct ich_spi_priv *ctlr = dev_get_priv(bus);
uint16_t control;
int16_t opcode_index;
@@ -477,7 +478,10 @@
if (ret < 0)
return ret;
- ich_writew(ctlr, SPIS_CDS | SPIS_FCERR, ctlr->status);
+ if (plat->ich_version == 7)
+ ich_writew(ctlr, SPIS_CDS | SPIS_FCERR, ctlr->status);
+ else
+ ich_writeb(ctlr, SPIS_CDS | SPIS_FCERR, ctlr->status);
spi_setup_type(trans, using_cmd ? bytes : 0);
opcode_index = spi_setup_opcode(ctlr, trans);