rockchip: px30-board-tpl: Sync ifdef guards with full TPL
Display TPL init information message only when TPL_BANNER_PRINT
configuration entry is set. This allows to disable information
message in case logs on UART are unwanted.
Update parent ifdef condition to check also CONFIG_TPL_SERIAL
to match logic of the non-PX30 TPL implementation.
Signed-off-by: Lukasz Czechowski <lukasz.czechowski@thaumatec.com>
Reviewed-by: Quentin Schulz <quentin.schulz@theobroma-systems.com>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/arch/arm/mach-rockchip/px30-board-tpl.c b/arch/arm/mach-rockchip/px30-board-tpl.c
index 637a5e1..db368a7 100644
--- a/arch/arm/mach-rockchip/px30-board-tpl.c
+++ b/arch/arm/mach-rockchip/px30-board-tpl.c
@@ -36,7 +36,7 @@
{
int ret;
-#ifdef CONFIG_DEBUG_UART
+#if defined(CONFIG_DEBUG_UART) && defined(CONFIG_TPL_SERIAL)
debug_uart_init();
/*
* Debug UART can be used from here if required:
@@ -46,8 +46,10 @@
* printhex8(0x1234);
* printascii("string");
*/
+#if CONFIG_TPL_BANNER_PRINT
printascii("U-Boot TPL board init\n");
#endif
+#endif
secure_timer_init();
ret = sdram_init();