imx: ventana: add GW5904 support
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
diff --git a/board/gateworks/gw_ventana/gw_ventana.c b/board/gateworks/gw_ventana/gw_ventana.c
index 3f9d2f7..0768799 100644
--- a/board/gateworks/gw_ventana/gw_ventana.c
+++ b/board/gateworks/gw_ventana/gw_ventana.c
@@ -132,8 +132,9 @@
/* toggle PHY_RST# */
gpio_request(gpio, "phy_rst#");
gpio_direction_output(gpio, 0);
- mdelay(2);
+ mdelay(10);
gpio_set_value(gpio, 1);
+ mdelay(100);
}
#ifdef CONFIG_USB_EHCI_MX6
@@ -231,6 +232,38 @@
return 0;
}
+
+#ifdef CONFIG_MV88E61XX_SWITCH
+int mv88e61xx_hw_reset(struct phy_device *phydev)
+{
+ struct mii_dev *bus = phydev->bus;
+
+ /* GPIO[0] output, CLK125 */
+ debug("enabling RGMII_REFCLK\n");
+ bus->write(bus, 0x1c /*MV_GLOBAL2*/, 0,
+ 0x1a /*MV_SCRATCH_MISC*/,
+ (1 << 15) | (0x62 /*MV_GPIO_DIR*/ << 8) | 0xfe);
+ bus->write(bus, 0x1c /*MV_GLOBAL2*/, 0,
+ 0x1a /*MV_SCRATCH_MISC*/,
+ (1 << 15) | (0x68 /*MV_GPIO01_CNTL*/ << 8) | 7);
+
+ /* RGMII delay - Physical Control register bit[15:14] */
+ debug("setting port%d RGMII rx/tx delay\n", CONFIG_MV88E61XX_CPU_PORT);
+ /* forced 1000mbps full-duplex link */
+ bus->write(bus, 0x10 + CONFIG_MV88E61XX_CPU_PORT, 0, 1, 0xc0fe);
+ phydev->autoneg = AUTONEG_DISABLE;
+ phydev->speed = SPEED_1000;
+ phydev->duplex = DUPLEX_FULL;
+
+ /* LED configuration: 7:4-green (8=Activity) 3:0 amber (9=10Link) */
+ bus->write(bus, 0x10, 0, 0x16, 0x8089);
+ bus->write(bus, 0x11, 0, 0x16, 0x8089);
+ bus->write(bus, 0x12, 0, 0x16, 0x8089);
+ bus->write(bus, 0x13, 0, 0x16, 0x8089);
+
+ return 0;
+}
+#endif // CONFIG_MV88E61XX_SWITCH
int board_eth_init(bd_t *bis)
{