mmc: rockchip_sdhci: Limit number of blocks read in a single command
Using DMA to load TF-A into SRAM fails when booting from eMMC on RK3588.
## Checking hash(es) for Image atf-3 ... sha256 error!
Bad hash value for 'hash' hash node in 'atf-3' image node
spl_load_simple_fit: can't load image loadables index 2 (ret = -1)
mmc_load_image_raw_sector: mmc block read error
Fix this by using PIO mode in SPL and limit the number of blocks used in
a single read command to avoid triggering Data End Bit Error interrupt.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/configs/rock5b-rk3588_defconfig b/configs/rock5b-rk3588_defconfig
index 3fcc6a2..d3136ac 100644
--- a/configs/rock5b-rk3588_defconfig
+++ b/configs/rock5b-rk3588_defconfig
@@ -58,6 +58,7 @@
CONFIG_MMC_DW_ROCKCHIP=y
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_SDMA=y
+# CONFIG_SPL_MMC_SDHCI_SDMA is not set
CONFIG_MMC_SDHCI_ROCKCHIP=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_GMAC_ROCKCHIP=y