env: Finish migration of common ENV options
- In ARMv8 NXP Layerscape platforms we also need to make use of
CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so.
- On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define
to 0.
- Add Kconfig entry for ENV_ADDR.
- Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it.
- Add ENV_xxx_REDUND options that depend on their primary option and
SYS_REDUNDAND_ENVIRONMENT
- On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR
for the pre-main-U-Boot environment location.
- On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but
rather it being non-zero, as it will now be zero by default.
- Rework the env_offset absolute in env/embedded.o to not use
CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within
ENV_IS_IN_FLASH.
- Migrate all platforms.
Cc: Wolfgang Denk <wd@denx.de>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Patrick Delaunay <patrick.delaunay@st.com>
Cc: uboot-stm32@st-md-mailman.stormreply.com
Signed-off-by: Tom Rini <trini@konsulko.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
diff --git a/configs/m53menlo_defconfig b/configs/m53menlo_defconfig
index 0a2cb4e..5401cc9 100644
--- a/configs/m53menlo_defconfig
+++ b/configs/m53menlo_defconfig
@@ -7,6 +7,8 @@
CONFIG_SYS_MALLOC_F_LEN=0x8000
CONFIG_TARGET_M53MENLO=y
CONFIG_SPL_SERIAL_SUPPORT=y
+CONFIG_ENV_SIZE=0x4000
+CONFIG_ENV_OFFSET=0x100000
CONFIG_NR_DRAM_BANKS=2
CONFIG_SPL=y
CONFIG_SYS_BOOTCOUNT_SINGLEWORD=y
@@ -57,6 +59,7 @@
CONFIG_DEFAULT_DEVICE_TREE="imx53-m53menlo"
CONFIG_ENV_IS_IN_NAND=y
CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
+CONFIG_ENV_OFFSET_REDUND=0x180000
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_DM=y
CONFIG_BOOTCOUNT_LIMIT=y