arm: mvebu: db-88f6820: Add SPL support with DDR init code
This patch adds SPL support for the Marvell DB-88F6820-GP board.
With this change, the bin_hdr from the original Marvell U-boot
is not needed any more on this board. The sources from bin_hdr
(SERDES/PHY and DDR setup) are now integrated in mainline
U-Boot. And this patch enables them for this board.
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/Marvell/db-88f6820-gp/db-88f6820-gp.c b/board/Marvell/db-88f6820-gp/db-88f6820-gp.c
index 51ac495..e661fa1 100644
--- a/board/Marvell/db-88f6820-gp/db-88f6820-gp.c
+++ b/board/Marvell/db-88f6820-gp/db-88f6820-gp.c
@@ -11,6 +11,8 @@
#include <asm/arch/cpu.h>
#include <asm/arch/soc.h>
+#include "../drivers/ddr/marvell/a38x/ddr3_a38x_topology.h"
+
DECLARE_GLOBAL_DATA_PTR;
#define BIT(nr) (1UL << (nr))
@@ -54,6 +56,35 @@
{ 0x21, 3, 0xC0 } /* Output Data, register#1 */
};
+/*
+ * Define the DDR layout / topology here in the board file. This will
+ * be used by the DDR3 init code in the SPL U-Boot version to configure
+ * the DDR3 controller.
+ */
+static struct hws_topology_map board_topology_map = {
+ 0x1, /* active interfaces */
+ /* cs_mask, mirror, dqs_swap, ck_swap X PUPs */
+ { { { {0x1, 0, 0, 0},
+ {0x1, 0, 0, 0},
+ {0x1, 0, 0, 0},
+ {0x1, 0, 0, 0},
+ {0x1, 0, 0, 0} },
+ SPEED_BIN_DDR_1866L, /* speed_bin */
+ BUS_WIDTH_8, /* memory_width */
+ MEM_4G, /* mem_size */
+ DDR_FREQ_800, /* frequency */
+ 0, 0, /* cas_l cas_wl */
+ HWS_TEMP_LOW} }, /* temperature */
+ 5, /* Num Of Bus Per Interface*/
+ BUS_MASK_32BIT /* Busses mask */
+};
+
+struct hws_topology_map *ddr3_get_topology_map(void)
+{
+ /* Return the board topology as defined in the board code */
+ return &board_topology_map;
+}
+
int board_early_init_f(void)
{
/* Configure MPP */