Qualcomm QUP SPI controller Device Tree Bindings
-------------------------------------------

Required properties:
- compatible : Should be "qcom,spi-qup-v1.1.1", "qcom,spi-qup-v2.1.1"
				or "qcom,spi-qup-v2.2.1"
- reg : Physical base address and size of SPI registers map.
- clock	: Clock phandle (see clock bindings for details).
- #address-cells : Number of cells required to define a chip select
			address on the SPI bus. Should be set to 1.
- #size-cells : Should be zero.
- pinctrl-names : Must be "default"
- pinctrl-n : At least one pinctrl phandle
- cs-gpios : Should specify GPIOs used for chipselects.
				The gpios will be referred to as reg = <index> in the
				SPI child nodes.

Optional properties:
- num-cs : total number of chipselects

Example:

	blsp1_spi1: spi@78b5000 {
		compatible = "qcom,spi-qup-v2.2.1";
		reg = <0x78b5000 0x600>;
		clock = <&gcc 23>;
		#address-cells = <1>;
		#size-cells = <0>;
		pinctrl-names = "spi";
		pinctrl-0 = <&blsp_spi0>;
		num-cs = <2>;
		cs-gpios = <&soc_gpios 54 GPIO_ACTIVE_HIGH>, <&soc_gpios 4 GPIO_ACTIVE_HIGH>;
	};