// SPDX-License-Identifier: GPL-2.0+

#include <dt-bindings/gpio/gpio.h>

/delete-node/ &usb3_vbus_reg;
/delete-node/ &usb_vbus_boost_pin;

/ {
	/* U-Boot uses different bindings for GPIO regulators, this
	 * one is required for USB
	 */
	usb3_vbus_reg: usb3_vbus_reg {
		compatible = "regulator-gpio";
		regulator-name = "usb3_vbus_reg";
		regulator-min-microvolt = <5000000>;
		regulator-max-microvolt = <5000000>;
		enable-gpios = <&pms405_gpios 3 GPIO_ACTIVE_HIGH>;
		enable-active-high;
		states = <0 0>, <5000000 1>;
	};
};

&blsp1_uart2 {
	/* This defines the bit clock divider which defines the baud rate.
	 * 0xFF is a divider of 16 for both the RX and TX lines. The QCS404
	 * clock driver in U-Boot hardcodes a 1843200Hz frequency for the
	 * UART core clock, and 1843200 / 16 = 115200.
	 */
	bit-rate = <0xFF>;
};

&gcc {
	/* The clock framework in U-Boot "sort of" has the idea of linking an
	 * individual clock to a device via uclass_priv. However the qcom clock
	 * driver instead associates many clocks with a single device. This is
	 * usually fine but it seems that assigned-clocks wreak havoc on this
	 * and we wind up having a reference to the XO clock which is associated
	 * with the qcom_clk device...
	 * For now we'll just remove these properties, no other board has these.
	 */
	/delete-property/ assigned-clock-rates;
	/delete-property/ assigned-clocks;
};

&usb3_dwc3 {
	/* Make sure the VBUS supply is switched on */
	vbus-supply = <&usb3_vbus_reg>;
};