Convert CONFIG_SYS_MEM_TOP_HIDE to Kconfig
This converts the following to Kconfig:
CONFIG_SYS_MEM_TOP_HIDE
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/Kconfig b/Kconfig
index b45e60a..e269856 100644
--- a/Kconfig
+++ b/Kconfig
@@ -489,6 +489,17 @@
by the UEFI sub-system. On some boards initrd_high is calculated as
base stack pointer minus this stack size.
+config SYS_MEM_TOP_HIDE
+ hex "Exclude some memory from U-Boot / OS information"
+ default 0x0
+ help
+ If set, this specified memory area will get subtracted from the top
+ (end) of RAM and won't get "touched" at all by U-Boot. By fixing up
+ gd->ram_size the OS / next stage should gets passed the now
+ "corrected" memory size and won't touch it either.
+ WARNING: Please make sure that this value is a multiple of the OS
+ page size.
+
config SYS_HAS_SRAM
bool
default y if TARGET_PIC32MZDASK
diff --git a/README b/README
index d503357..1967961 100644
--- a/README
+++ b/README
@@ -1876,27 +1876,6 @@
the RAM base is not zero, or RAM is divided into banks,
this variable needs to be recalcuated to get the address.
-- CONFIG_SYS_MEM_TOP_HIDE:
- If CONFIG_SYS_MEM_TOP_HIDE is defined in the board config header,
- this specified memory area will get subtracted from the top
- (end) of RAM and won't get "touched" at all by U-Boot. By
- fixing up gd->ram_size the Linux kernel should gets passed
- the now "corrected" memory size and won't touch it either.
- This should work for arch/ppc and arch/powerpc. Only Linux
- board ports in arch/powerpc with bootwrapper support that
- recalculate the memory size from the SDRAM controller setup
- will have to get fixed in Linux additionally.
-
- This option can be used as a workaround for the 440EPx/GRx
- CHIP 11 errata where the last 256 bytes in SDRAM shouldn't
- be touched.
-
- WARNING: Please make sure that this value is a multiple of
- the Linux page size (normally 4k). If this is not the case,
- then the end address of the Linux memory will be located at a
- non page size aligned address and this could cause major
- problems.
-
- CONFIG_SYS_LOADS_BAUD_CHANGE:
Enable temporary baudrate change while serial download
diff --git a/board/samsung/common/board.c b/board/samsung/common/board.c
index 97791aa..ff178b7 100644
--- a/board/samsung/common/board.c
+++ b/board/samsung/common/board.c
@@ -107,9 +107,9 @@
}
boot_temp_check();
#endif
-#ifdef CONFIG_TZSW_RESERVED_DRAM_SIZE
+#if CONFIG_VAL(SYS_MEM_TOP_HIDE)
/* The last few MB of memory can be reserved for secure firmware */
- ulong size = CONFIG_TZSW_RESERVED_DRAM_SIZE;
+ ulong size = CONFIG_SYS_MEM_TOP_HIDE;
gd->ram_size -= size;
gd->bd->bi_dram[CONFIG_NR_DRAM_BANKS - 1].size -= size;
diff --git a/common/board_f.c b/common/board_f.c
index 5b655ad..4d7e400 100644
--- a/common/board_f.c
+++ b/common/board_f.c
@@ -327,7 +327,7 @@
* Ram is setup, size stored in gd !!
*/
debug("Ram size: %08lX\n", (ulong)gd->ram_size);
-#if defined(CONFIG_SYS_MEM_TOP_HIDE)
+#if CONFIG_VAL(SYS_MEM_TOP_HIDE)
/*
* Subtract specified amount of memory to hide so that it won't
* get "touched" at all by U-Boot. By fixing up gd->ram_size
diff --git a/configs/odroid-xu3_defconfig b/configs/odroid-xu3_defconfig
index d7f9c20..250c0b4 100644
--- a/configs/odroid-xu3_defconfig
+++ b/configs/odroid-xu3_defconfig
@@ -13,6 +13,7 @@
CONFIG_SYS_LOAD_ADDR=0x43e00000
CONFIG_DISTRO_DEFAULTS=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_SYS_MEM_TOP_HIDE=0x01600000
CONFIG_FIT=y
CONFIG_FIT_BEST_MATCH=y
CONFIG_SILENT_CONSOLE=y
diff --git a/configs/odroid_defconfig b/configs/odroid_defconfig
index 9f5688e..058e7dc 100644
--- a/configs/odroid_defconfig
+++ b/configs/odroid_defconfig
@@ -14,6 +14,7 @@
CONFIG_SYS_LOAD_ADDR=0x43e00000
CONFIG_DISTRO_DEFAULTS=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_SYS_MEM_TOP_HIDE=0x00100000
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_USE_BOOTARGS=y
diff --git a/configs/origen_defconfig b/configs/origen_defconfig
index 6ffec86..b4b0d8b 100644
--- a/configs/origen_defconfig
+++ b/configs/origen_defconfig
@@ -16,6 +16,7 @@
CONFIG_IDENT_STRING=" for ORIGEN"
CONFIG_SYS_LOAD_ADDR=0x43e00000
CONFIG_DISTRO_DEFAULTS=y
+CONFIG_SYS_MEM_TOP_HIDE=0x100000
CONFIG_BOOTCOMMAND="if mmc rescan; then echo SD/MMC found on device ${mmcdev};if run loadbootenv; then echo Loaded environment from ${bootenv};run importbootenv;fi;if test -n $uenvcmd; then echo Running uenvcmd ...;run uenvcmd;fi;if run loadbootscript; then run bootscript; fi; fi;load mmc ${mmcdev} ${loadaddr} uImage; bootm ${loadaddr} "
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_SYS_CONSOLE_INFO_QUIET=y
diff --git a/configs/s5pc210_universal_defconfig b/configs/s5pc210_universal_defconfig
index 8a34908..e70ce25 100644
--- a/configs/s5pc210_universal_defconfig
+++ b/configs/s5pc210_universal_defconfig
@@ -13,6 +13,7 @@
CONFIG_DEFAULT_DEVICE_TREE="exynos4210-universal_c210"
CONFIG_SYS_LOAD_ADDR=0x44800000
CONFIG_DISTRO_DEFAULTS=y
+CONFIG_SYS_MEM_TOP_HIDE=0x100000
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="Please use defined boot"
CONFIG_BOOTCOMMAND="run mmcboot"
diff --git a/configs/theadorable_debug_defconfig b/configs/theadorable_debug_defconfig
index 64ae291..230c086 100644
--- a/configs/theadorable_debug_defconfig
+++ b/configs/theadorable_debug_defconfig
@@ -20,6 +20,7 @@
CONFIG_SYS_LOAD_ADDR=0x800000
CONFIG_DEBUG_UART=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_SYS_MEM_TOP_HIDE=0x80000
CONFIG_FIT=y
CONFIG_BOOTDELAY=3
CONFIG_USE_PREBOOT=y
diff --git a/configs/trats2_defconfig b/configs/trats2_defconfig
index b38ee99..690cdef 100644
--- a/configs/trats2_defconfig
+++ b/configs/trats2_defconfig
@@ -13,6 +13,7 @@
CONFIG_SYS_LOAD_ADDR=0x43e00000
CONFIG_DISTRO_DEFAULTS=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_SYS_MEM_TOP_HIDE=0x100000
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_USE_BOOTARGS=y
diff --git a/configs/trats_defconfig b/configs/trats_defconfig
index d068944..1889079 100644
--- a/configs/trats_defconfig
+++ b/configs/trats_defconfig
@@ -12,6 +12,7 @@
CONFIG_DEFAULT_DEVICE_TREE="exynos4210-trats"
CONFIG_SYS_LOAD_ADDR=0x44800000
CONFIG_DISTRO_DEFAULTS=y
+CONFIG_SYS_MEM_TOP_HIDE=0x100000
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_USE_BOOTARGS=y
diff --git a/include/configs/odroid.h b/include/configs/odroid.h
index 42031bb..b8b47af 100644
--- a/include/configs/odroid.h
+++ b/include/configs/odroid.h
@@ -21,9 +21,6 @@
#define CONFIG_SYS_SDRAM_BASE 0x40000000
#define SDRAM_BANK_SIZE (256 << 20) /* 256 MB */
#define PHYS_SDRAM_1 CONFIG_SYS_SDRAM_BASE
-/* Reserve the last 1 MiB for the secure firmware */
-#define CONFIG_SYS_MEM_TOP_HIDE (1UL << 20UL)
-#define CONFIG_TZSW_RESERVED_DRAM_SIZE CONFIG_SYS_MEM_TOP_HIDE
#include <linux/sizes.h>
diff --git a/include/configs/odroid_xu3.h b/include/configs/odroid_xu3.h
index 616f25e..eb35d7b 100644
--- a/include/configs/odroid_xu3.h
+++ b/include/configs/odroid_xu3.h
@@ -15,9 +15,6 @@
#define TZPC_BASE_OFFSET 0x10000
#define SDRAM_BANK_SIZE (256UL << 20UL) /* 256 MB */
-/* Reserve the last 22 MiB for the secure firmware */
-#define CONFIG_SYS_MEM_TOP_HIDE (22UL << 20UL)
-#define CONFIG_TZSW_RESERVED_DRAM_SIZE CONFIG_SYS_MEM_TOP_HIDE
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_LOAD_ADDR - 0x1000000)
diff --git a/include/configs/origen.h b/include/configs/origen.h
index 278c204..c4f5997 100644
--- a/include/configs/origen.h
+++ b/include/configs/origen.h
@@ -19,8 +19,6 @@
#define PHYS_SDRAM_1 CONFIG_SYS_SDRAM_BASE
#define SDRAM_BANK_SIZE (256 << 20) /* 256 MB */
-#define CONFIG_SYS_MEM_TOP_HIDE (1 << 20) /* ram console */
-
/* Power Down Modes */
#define S5P_CHECK_SLEEP 0x00000BAD
#define S5P_CHECK_DIDLE 0xBAD00000
diff --git a/include/configs/s5pc210_universal.h b/include/configs/s5pc210_universal.h
index 8cbdbc7..ae56c66 100644
--- a/include/configs/s5pc210_universal.h
+++ b/include/configs/s5pc210_universal.h
@@ -24,8 +24,6 @@
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_LOAD_ADDR \
- GENERATED_GBL_DATA_SIZE)
-#define CONFIG_SYS_MEM_TOP_HIDE (1 << 20) /* ram console */
-
/* Actual modem binary size is 16MiB. Add 2MiB for bad block handling */
#define NORMAL_MTDPARTS_DEFAULT CONFIG_MTDPARTS_DEFAULT
diff --git a/include/configs/theadorable.h b/include/configs/theadorable.h
index 14817b1..fdf048b 100644
--- a/include/configs/theadorable.h
+++ b/include/configs/theadorable.h
@@ -43,9 +43,6 @@
/* SATA support */
#define CONFIG_LBA48
-/* Enable LCD and reserve 512KB from top of memory*/
-#define CONFIG_SYS_MEM_TOP_HIDE 0x80000
-
/* FPGA programming support */
#define CONFIG_FPGA_STRATIX_V
diff --git a/include/configs/trats.h b/include/configs/trats.h
index 41ac609..910fc15 100644
--- a/include/configs/trats.h
+++ b/include/configs/trats.h
@@ -28,8 +28,6 @@
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_LOAD_ADDR \
- GENERATED_GBL_DATA_SIZE)
-#define CONFIG_SYS_MEM_TOP_HIDE (1 << 20) /* ram console */
-
/* Tizen - partitions definitions */
#define PARTS_CSA "csa-mmc"
#define PARTS_BOOT "boot"
diff --git a/include/configs/trats2.h b/include/configs/trats2.h
index a980e6c..3e121bc 100644
--- a/include/configs/trats2.h
+++ b/include/configs/trats2.h
@@ -27,8 +27,6 @@
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_LOAD_ADDR \
- GENERATED_GBL_DATA_SIZE)
-#define CONFIG_SYS_MEM_TOP_HIDE (1 << 20) /* ram console */
-
/* Tizen - partitions definitions */
#define PARTS_CSA "csa-mmc"
#define PARTS_BOOT "boot"