arm: socfpga: vining: Let DWMAC configure PHY reset GPIO
The DM DWMAC driver is perfectly capable of configuring the ethernet
PHY reset GPIO, let the driver do it instead of doing it in the board
file.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Siew Chin Lim <elly.siew.chin.lim@intel.com>
Cc: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
Cc: Tien Fong Chee <tien.fong.chee@intel.com>
diff --git a/board/softing/vining_fpga/socfpga.c b/board/softing/vining_fpga/socfpga.c
index aaedf03..2299227 100644
--- a/board/softing/vining_fpga/socfpga.c
+++ b/board/softing/vining_fpga/socfpga.c
@@ -23,7 +23,6 @@
*/
int board_late_init(void)
{
- const unsigned int phy_nrst_gpio = 0;
const unsigned int usb_nrst_gpio = 35;
int ret;
@@ -33,12 +32,6 @@
/* Address of boot parameters for ATAG (if ATAG is used) */
gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
- ret = gpio_request(phy_nrst_gpio, "phy_nrst_gpio");
- if (!ret)
- gpio_direction_output(phy_nrst_gpio, 1);
- else
- printf("Cannot remove PHY from reset!\n");
-
ret = gpio_request(usb_nrst_gpio, "usb_nrst_gpio");
if (!ret)
gpio_direction_output(usb_nrst_gpio, 1);