ARM: DRA7: Add ABB setup for all domains
ABB should be initialized for all required domains voltage domain
for DRA7: IVA, GPU, EVE in addition to the existing MPU domain. If
we do not do this, kernel configuring just the frequency using the
default boot loader configured voltage can fail on many corner lot
units and has been hard to debug. This specifically is a concern with
DRA7 generation of SoCs since other than VDD_MPU, all other domains
are only permitted to setup the voltages to required OPP only at boot.
Reported-by: Richard Woodruff <r-woodruff2@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
diff --git a/arch/arm/cpu/armv7/omap-common/clocks-common.c b/arch/arm/cpu/armv7/omap-common/clocks-common.c
index da57b38..ef2ac98 100644
--- a/arch/arm/cpu/armv7/omap-common/clocks-common.c
+++ b/arch/arm/cpu/armv7/omap-common/clocks-common.c
@@ -596,10 +596,34 @@
debug("gpu: %d\n", vcores->gpu.value);
do_scale_vcore(vcores->gpu.addr, vcores->gpu.value, vcores->gpu.pmic);
+ /* Configure GPU ABB LDO after scale */
+ abb_setup(vcores->gpu.efuse.reg,
+ (*ctrl)->control_wkup_ldovbb_gpu_voltage_ctrl,
+ (*prcm)->prm_abbldo_gpu_setup,
+ (*prcm)->prm_abbldo_gpu_ctrl,
+ (*prcm)->prm_irqstatus_mpu,
+ vcores->gpu.abb_tx_done_mask,
+ OMAP_ABB_FAST_OPP);
debug("eve: %d\n", vcores->eve.value);
do_scale_vcore(vcores->eve.addr, vcores->eve.value, vcores->eve.pmic);
+ /* Configure EVE ABB LDO after scale */
+ abb_setup(vcores->eve.efuse.reg,
+ (*ctrl)->control_wkup_ldovbb_eve_voltage_ctrl,
+ (*prcm)->prm_abbldo_eve_setup,
+ (*prcm)->prm_abbldo_eve_ctrl,
+ (*prcm)->prm_irqstatus_mpu,
+ vcores->eve.abb_tx_done_mask,
+ OMAP_ABB_FAST_OPP);
debug("iva: %d\n", vcores->iva.value);
do_scale_vcore(vcores->iva.addr, vcores->iva.value, vcores->iva.pmic);
+ /* Configure IVA ABB LDO after scale */
+ abb_setup(vcores->iva.efuse.reg,
+ (*ctrl)->control_wkup_ldovbb_iva_voltage_ctrl,
+ (*prcm)->prm_abbldo_iva_setup,
+ (*prcm)->prm_abbldo_iva_ctrl,
+ (*prcm)->prm_irqstatus_mpu,
+ vcores->iva.abb_tx_done_mask,
+ OMAP_ABB_FAST_OPP);
/* Might need udelay(1000) here if debug is enabled to see all prints */
#else
u32 val;