rockchip: roc-rk3399-pc: Set LED only during POR and pwr_key=y
ROC-RK3399-PC has specific set of configurations for
on-board led setup.
Due to easiness for user to know the state of the board
roc-rk339-pc board code will setup the low power led
on/off, and waiting for user to press power key and then
glow full power led.
All this needs to happen only during power-on-reset not
for soft reset or WDT.
Also, it is not a proper usage to ask the user to press
the Power key if the board connected remotely, so add
the environment variable 'pwr_key' to check as well.
So, user need to press Power key only
- during POR
- pwr_key=y
Tested-by: Suniel Mahesh <sunil@amarulasolutions.com>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/configs/roc-pc-rk3399_defconfig b/configs/roc-pc-rk3399_defconfig
index 2a6d0d2..6181da7 100644
--- a/configs/roc-pc-rk3399_defconfig
+++ b/configs/roc-pc-rk3399_defconfig
@@ -19,7 +19,8 @@
CONFIG_DISPLAY_BOARDINFO_LATE=y
# CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
CONFIG_SPL_STACK_R=y
-CONFIG_SPL_STACK_R_MALLOC_SIMPLE_LEN=0x10000
+CONFIG_SPL_STACK_R_MALLOC_SIMPLE_LEN=0x20000
+CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_TPL=y
CONFIG_CMD_BOOTZ=y
@@ -33,6 +34,7 @@
CONFIG_OF_SPL_REMOVE_PROPS="pinctrl-0 pinctrl-names clock-names interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+CONFIG_SPL_DM_SEQ_ALIAS=y
CONFIG_ROCKCHIP_GPIO=y
CONFIG_SYS_I2C_ROCKCHIP=y
CONFIG_MISC=y