Squashed 'dts/upstream/' content from commit aaba2d45dc2a
git-subtree-dir: dts/upstream
git-subtree-split: aaba2d45dc2a1b3bbb710f2a3808ee1c9f340abe
diff --git a/Bindings/powerpc/sleep.yaml b/Bindings/powerpc/sleep.yaml
new file mode 100644
index 0000000..1b0936a
--- /dev/null
+++ b/Bindings/powerpc/sleep.yaml
@@ -0,0 +1,47 @@
+# SPDX-License-Identifier: GPL-2.0-only
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/powerpc/sleep.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: PowerPC sleep property
+
+maintainers:
+ - Rob Herring <robh@kernel.org>
+
+description: |
+ Devices on SOCs often have mechanisms for placing devices into low-power
+ states that are decoupled from the devices' own register blocks. Sometimes,
+ this information is more complicated than a cell-index property can
+ reasonably describe. Thus, each device controlled in such a manner
+ may contain a "sleep" property which describes these connections.
+
+ The sleep property consists of one or more sleep resources, each of
+ which consists of a phandle to a sleep controller, followed by a
+ controller-specific sleep specifier of zero or more cells.
+
+ The semantics of what type of low power modes are possible are defined
+ by the sleep controller. Some examples of the types of low power modes
+ that may be supported are:
+
+ - Dynamic: The device may be disabled or enabled at any time.
+ - System Suspend: The device may request to be disabled or remain
+ awake during system suspend, but will not be disabled until then.
+ - Permanent: The device is disabled permanently (until the next hard
+ reset).
+
+ Some devices may share a clock domain with each other, such that they should
+ only be suspended when none of the devices are in use. Where reasonable,
+ such nodes should be placed on a virtual bus, where the bus has the sleep
+ property. If the clock domain is shared among devices that cannot be
+ reasonably grouped in this manner, then create a virtual sleep controller
+ (similar to an interrupt nexus, except that defining a standardized
+ sleep-map should wait until its necessity is demonstrated).
+
+select: true
+
+properties:
+ sleep:
+ $ref: /schemas/types.yaml#/definitions/phandle-array
+
+additionalProperties: true