diff --git a/Bindings/phy/phy-lantiq-rcu-usb2.txt b/Bindings/phy/phy-lantiq-rcu-usb2.txt
new file mode 100644
index 0000000..643948b6
--- /dev/null
+++ b/Bindings/phy/phy-lantiq-rcu-usb2.txt
@@ -0,0 +1,40 @@
+Lantiq XWAY SoC RCU USB 1.1/2.0 PHY binding
+===========================================
+
+This binding describes the USB PHY hardware provided by the RCU module on the
+Lantiq XWAY SoCs.
+
+This node has to be a sub node of the Lantiq RCU block.
+
+-------------------------------------------------------------------------------
+Required properties (controller (parent) node):
+- compatible	: Should be one of
+			"lantiq,ase-usb2-phy"
+			"lantiq,danube-usb2-phy"
+			"lantiq,xrx100-usb2-phy"
+			"lantiq,xrx200-usb2-phy"
+			"lantiq,xrx300-usb2-phy"
+- reg		: Defines the following sets of registers in the parent
+		  syscon device
+			- Offset of the USB PHY configuration register
+			- Offset of the USB Analog configuration
+			  register (only for xrx200 and xrx200)
+- clocks	: References to the (PMU) "phy" clk gate.
+- clock-names	: Must be "phy"
+- resets	: References to the RCU USB configuration reset bits.
+- reset-names	: Must be one of the following:
+			"phy" (optional)
+			"ctrl" (shared)
+
+-------------------------------------------------------------------------------
+Example for the USB PHYs on an xRX200 SoC:
+	usb_phy0: usb2-phy@18 {
+		compatible = "lantiq,xrx200-usb2-phy";
+		reg = <0x18 4>, <0x38 4>;
+
+		clocks = <&pmu PMU_GATE_USB0_PHY>;
+		clock-names = "phy";
+		resets = <&reset1 4 4>, <&reset0 4 4>;
+		reset-names = "phy", "ctrl";
+		#phy-cells = <0>;
+	};