Squashed 'dts/upstream/' content from commit aaba2d45dc2a
git-subtree-dir: dts/upstream
git-subtree-split: aaba2d45dc2a1b3bbb710f2a3808ee1c9f340abe
diff --git a/Bindings/media/i2c/toshiba,et8ek8.txt b/Bindings/media/i2c/toshiba,et8ek8.txt
new file mode 100644
index 0000000..e80d589
--- /dev/null
+++ b/Bindings/media/i2c/toshiba,et8ek8.txt
@@ -0,0 +1,55 @@
+Toshiba et8ek8 5MP sensor
+
+Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device
+
+More detailed documentation can be found in
+Documentation/devicetree/bindings/media/video-interfaces.txt .
+
+
+Mandatory properties
+--------------------
+
+- compatible: "toshiba,et8ek8"
+- reg: I2C address (0x3e, or an alternative address)
+- vana-supply: Analogue voltage supply (VANA), 2.8 volts
+- clocks: External clock to the sensor
+- clock-frequency: Frequency of the external clock to the sensor. Camera
+ driver will set this frequency on the external clock. The clock frequency is
+ a pre-determined frequency known to be suitable to the board.
+- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
+ is in hardware standby mode when the signal is in the low state.
+
+
+Optional properties
+-------------------
+
+- flash-leds: See ../video-interfaces.txt
+- lens-focus: See ../video-interfaces.txt
+
+
+Endpoint node mandatory properties
+----------------------------------
+
+- remote-endpoint: A phandle to the bus receiver's endpoint node.
+
+
+Example
+-------
+
+&i2c3 {
+ clock-frequency = <400000>;
+
+ cam1: camera@3e {
+ compatible = "toshiba,et8ek8";
+ reg = <0x3e>;
+ vana-supply = <&vaux4>;
+ clocks = <&isp 0>;
+ clock-frequency = <9600000>;
+ reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */
+ port {
+ csi_cam1: endpoint {
+ remote-endpoint = <&csi_out1>;
+ };
+ };
+ };
+};