diff --git a/Bindings/gpio/gpio_atmel.txt b/Bindings/gpio/gpio_atmel.txt
new file mode 100644
index 0000000..29416f9
--- /dev/null
+++ b/Bindings/gpio/gpio_atmel.txt
@@ -0,0 +1,31 @@
+* Atmel GPIO controller (PIO)
+
+Required properties:
+- compatible: "atmel,<chip>-gpio", where <chip> is at91rm9200 or at91sam9x5.
+- reg: Should contain GPIO controller registers location and length
+- interrupts: Should be the port interrupt shared by all the pins.
+- #gpio-cells: Should be two.  The first cell is the pin number and
+  the second cell is used to specify optional parameters to declare if the GPIO
+  is active high or low. See gpio.txt.
+- gpio-controller: Marks the device node as a GPIO controller.
+- interrupt-controller: Marks the device node as an interrupt controller.
+- #interrupt-cells: Should be two. The first cell is the pin number and the
+  second cell is used to specify irq type flags, see the two cell description
+  in interrupt-controller/interrupts.txt for details.
+
+optional properties:
+- #gpio-lines: Number of gpio if absent 32.
+
+
+Example:
+	pioA: gpio@fffff200 {
+		compatible = "atmel,at91rm9200-gpio";
+		reg = <0xfffff200 0x100>;
+		interrupts = <2 4>;
+		#gpio-cells = <2>;
+		gpio-controller;
+		#gpio-lines = <19>;
+		interrupt-controller;
+		#interrupt-cells = <2>;
+	};
+