i.MX6: engicam: Add imx6q/imx6ul boards for existing boards
Add new board names for existing board support
imx6q - icore and icore_rqs boards
imx6ul - geam6ul and isiot boards
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
diff --git a/board/engicam/imx6ul/README b/board/engicam/imx6ul/README
new file mode 100644
index 0000000..1e85f61
--- /dev/null
+++ b/board/engicam/imx6ul/README
@@ -0,0 +1,33 @@
+Hsow to use U-Boot on Engicam GEAM6UL and Is.IoT MX6UL Starter Kit:
+-------------------------------------------------------------------
+
+$ make mrproper
+
+- Configure U-Boot for Engicam GEAM6UL:
+$ make imx6ul_geam_mmc_defconfig
+
+- Configure U-Boot for Engicam Is.IoT MX6UL:
+$ make imx6ul_isiot_mmc_defconfig
+
+- Build U-Boot
+$ make
+
+This will generate the SPL image called SPL and the u-boot-dtb.img.
+
+- Flash the SPL image into the micro SD card:
+
+sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
+
+- Flash the u-boot-dtb.img image into the micro SD card:
+
+sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
+
+- Jumper settings:
+
+MMC Boot: JM3 Closed
+
+- Connect the Serial cable between the Starter Kit and the PC for the console.
+(J28 is the Linux Serial console connector)
+
+- Insert the micro SD card in the board, power it up and U-Boot messages should
+come up.