rockchip: spl: Drop MMC support code when not needed
When the board does not use MMC SPL this code is a waste of space. Drop it.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/arch/arm/mach-rockchip/rk3288-board-spl.c b/arch/arm/mach-rockchip/rk3288-board-spl.c
index f61eeab..9fdd37d 100644
--- a/arch/arm/mach-rockchip/rk3288-board-spl.c
+++ b/arch/arm/mach-rockchip/rk3288-board-spl.c
@@ -111,9 +111,9 @@
write_l2ctlr(l2ctlr);
}
+#ifdef CONFIG_SPL_MMC_SUPPORT
static int configure_emmc(struct udevice *pinctrl)
{
-#ifdef CONFIG_SPL_MMC_SUPPORT
struct gpio_desc desc;
int ret;
@@ -143,10 +143,10 @@
debug("gpio value ret=%d\n", ret);
return ret;
}
-#endif
return 0;
}
+#endif
void board_init_f(ulong dummy)
{
@@ -244,6 +244,7 @@
debug("%s: Cannot find pinctrl device\n", __func__);
goto err;
}
+#ifdef CONFIG_SPL_MMC_SUPPORT
ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_SDCARD);
if (ret) {
debug("%s: Failed to set up SD card\n", __func__);
@@ -254,6 +255,7 @@
debug("%s: Failed to set up eMMC\n", __func__);
goto err;
}
+#endif
/* Enable debug UART */
ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_UART_DBG);