configs: stm32mp15: enable LOG features

Activate the logging features in SPL and U-Boot
(CONFIG_LOG and CONFIG_SPL_LOG) and the command 'log' with
CONFIG_CMD_LOG.

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
diff --git a/configs/stm32mp15_basic_defconfig b/configs/stm32mp15_basic_defconfig
index 1843bbc..9ad7c3a 100644
--- a/configs/stm32mp15_basic_defconfig
+++ b/configs/stm32mp15_basic_defconfig
@@ -21,6 +21,7 @@
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT=y
 CONFIG_BOOTCOMMAND="run bootcmd_stm32mp"
+CONFIG_SPL_LOG=y
 CONFIG_BOARD_EARLY_INIT_F=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=3
@@ -54,6 +55,7 @@
 CONFIG_CMD_REGULATOR=y
 CONFIG_CMD_EXT4_WRITE=y
 CONFIG_CMD_MTDPARTS=y
+CONFIG_CMD_LOG=y
 CONFIG_CMD_UBI=y
 # CONFIG_SPL_DOS_PARTITION is not set
 CONFIG_OF_SPL_REMOVE_PROPS="interrupts interrupt-names interrupts-extended interrupt-controller \\\#interrupt-cells interrupt-parent dmas dma-names assigned-clocks assigned-clock-rates assigned-clock-parents hwlocks"