Get MPC8641HPCN flash images working.
Enable the CFI driver.
Remove bogus LAWBAR7 cruft.
Use correct TEXT_BASE, Fixup load script.
Enable SPD EEPROM during DDR setup.
Use generic RFC 1918 IP addresses by default.
diff --git a/board/mpc8641hpcn/config.mk b/board/mpc8641hpcn/config.mk
index 63b9779..4bdceec 100644
--- a/board/mpc8641hpcn/config.mk
+++ b/board/mpc8641hpcn/config.mk
@@ -25,8 +25,7 @@
# default CCSRBAR is at 0xff700000
# assume U-Boot is less than 0.5MB
#
-#TEXT_BASE = 0xfff01000
-TEXT_BASE = 0x00400000
+TEXT_BASE = 0xfff01000
PLATFORM_CPPFLAGS += -DCONFIG_MPC86xx=1
PLATFORM_CPPFLAGS += -DCONFIG_MPC8641=1 -maltivec -mabi=altivec -msoft-float
diff --git a/board/mpc8641hpcn/init.S b/board/mpc8641hpcn/init.S
index 9d43de5..4d555a5 100644
--- a/board/mpc8641hpcn/init.S
+++ b/board/mpc8641hpcn/init.S
@@ -80,23 +80,6 @@
#define LAWAR7 (LAWAR_EN | LAWAR_TRGT_IF_LBC | (LAWAR_SIZE & LAWAR_SIZE_32M))
-/*
- * Rapid IO at 0xc000_0000 for 512 M
- */
-/*
-#ifdef CFG_INIT_RAM_LOCK
-#define LAWBAR7 ((CFG_RIO_MEM_BASE>>12) & 0xffffff)
-#define LAWAR7 (LAWAR_EN | LAWAR_TRGT_IF_RIO | (LAWAR_SIZE & LAWAR_SIZE_512M))
-#endif
-*/
-/*
- * Stack at 0xfc00_0000 for 32M on LBC
- */
-#if !defined(CFG_INIT_RAM_LOCK)
-#define LAWBAR7 ((CFG_INIT_RAM_ADDR>>12) & 0xffffff)
-#define LAWAR7 (LAWAR_EN | LAWAR_TRGT_IF_LBC | (LAWAR_SIZE & LAWAR_SIZE_32M))
-#endif
-
.section .bootpg, "ax"
.globl law_entry
law_entry:
diff --git a/board/mpc8641hpcn/u-boot.lds b/board/mpc8641hpcn/u-boot.lds
index dbe8e4f..c5c40e7 100644
--- a/board/mpc8641hpcn/u-boot.lds
+++ b/board/mpc8641hpcn/u-boot.lds
@@ -28,7 +28,7 @@
__DYNAMIC = 0; */
SECTIONS
{
-/* .resetvec 0xFFF00100 :
+ .resetvec 0xFFF00100 :
{
*(.resetvec)
} = 0xffff
@@ -38,7 +38,7 @@
cpu/mpc86xx/start.o (.bootpg)
board/mpc8641hpcn/init.o (.bootpg)
} = 0xffff
-*/
+
/* Read-only sections, merged into text segment: */
. = + 1024;
.interp : { *(.interp) }
diff --git a/include/configs/MPC8641HPCN.h b/include/configs/MPC8641HPCN.h
index 76efd7c..d4a28ed 100644
--- a/include/configs/MPC8641HPCN.h
+++ b/include/configs/MPC8641HPCN.h
@@ -51,6 +51,7 @@
#define CONFIG_TSEC_ENET /* tsec ethernet support */
#define CONFIG_ENV_OVERWRITE
+#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup*/
#undef CONFIG_DDR_DLL /* possible DLL fix needed */
#define CONFIG_DDR_2T_TIMING /* Sets the 2T timing bit */
#define CONFIG_DDR_ECC /* only for ECC DDR module */
@@ -102,11 +103,9 @@
#else
/*
- * Manually set up DDR parameters
+ * Manually set up DDR1 parameters
*/
-/* DDR I */
-#if 1
#define CFG_SDRAM_SIZE 256 /* DDR is 256MB */
#define CFG_DDR_CS0_BNDS 0x0000000F
@@ -125,15 +124,14 @@
#define CFG_DDR_CONTROL 0xe3008000 /* Type = DDR2 */
#define CFG_DDR_CONTROL2 0x04400000
- //Not used in fixed_sdram function
+ /* Not used in fixed_sdram function */
#define CFG_DDR_MODE 0x00000022
#define CFG_DDR_CS1_BNDS 0x00000000
- #define CFG_DDR_CS2_BNDS 0x00000FFF //Not done
- #define CFG_DDR_CS3_BNDS 0x00000FFF //Not done
- #define CFG_DDR_CS4_BNDS 0x00000FFF //Not done
- #define CFG_DDR_CS5_BNDS 0x00000FFF //Not done
-#endif
+ #define CFG_DDR_CS2_BNDS 0x00000FFF /* Not done */
+ #define CFG_DDR_CS3_BNDS 0x00000FFF /* Not done */
+ #define CFG_DDR_CS4_BNDS 0x00000FFF /* Not done */
+ #define CFG_DDR_CS5_BNDS 0x00000FFF /* Not done */
#endif
@@ -190,6 +188,7 @@
#define CFG_FLASH_WRITE_TOUT 500 /* Flash Write Timeout (ms) */
#define CFG_MONITOR_BASE TEXT_BASE /* start of monitor */
+#define CFG_FLASH_CFI_DRIVER
#define CFG_FLASH_CFI
#define CFG_FLASH_EMPTY_INFO
@@ -199,14 +198,14 @@
#undef CFG_RAMBOOT
#endif
-#if !defined(CFG_RAMBOOT)
-#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup*/
+#if !defined(CONFIG_SPD_EEPROM) && !defined(CFG_RAMBOOT)
+#undef CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup*/
#endif
#undef CONFIG_CLOCKS_IN_MHZ
#define CONFIG_L1_INIT_RAM
-#undef CFG_INIT_RAM_LOCK
+#define CFG_INIT_RAM_LOCK 1
#ifndef CFG_INIT_RAM_LOCK
#define CFG_INIT_RAM_ADDR 0x0fd00000 /* Initial RAM address */
#else
@@ -540,22 +539,21 @@
#define CONFIG_HAS_ETH2 1
#define CONFIG_HAS_ETH3 1
-#define CONFIG_IPADDR 10.82.193.138
+#define CONFIG_IPADDR 192.168.1.100
#define CONFIG_HOSTNAME unknown
#define CONFIG_ROOTPATH /opt/nfsroot
#define CONFIG_BOOTFILE uImage
#define CONFIG_SERVERIP 192.168.1.1
-#define CONFIG_GATEWAYIP 10.82.193.104
+#define CONFIG_GATEWAYIP 192.168.1.1
#define CONFIG_NETMASK 255.255.255.0
/* default location for tftp and bootm */
#define CONFIG_LOADADDR 1000000
#define CONFIG_BOOTDELAY 10 /* -1 disables auto-boot */
-//#undef CONFIG_BOOTARGS /* the boot command will set bootargs */
-#define CONFIG_BOOTARGS "root=/dev/ram rw console=ttyS0,115200"
+#undef CONFIG_BOOTARGS /* the boot command will set bootargs */
#define CONFIG_BAUDRATE 115200