i2c: Update references to individual i2c commands
The individual i2c commands imd, imm, inm, imw, icrc32, iprobe, iloop,
and isdram are no longer available so all references to them have been
updated to the new form of "i2c <cmd>".
Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
diff --git a/doc/README.xpedite1k b/doc/README.xpedite1k
index 34bba13..1da8b80 100644
--- a/doc/README.xpedite1k
+++ b/doc/README.xpedite1k
@@ -23,7 +23,7 @@
change the 1st page of the EEPROM! Unpopulated jumper J560 can get you
out of trouble as it disables the strapping read from EEPROM.
-I2C iprobe
+I2C probe
=====================
The i2c utilities work and have been tested on Rev B. of the 440GX. See
@@ -47,10 +47,10 @@
This will select the default sys0 and sys1 settings (the serial
eeproms are not used). Then power up the board and fix the serial
-eeprom using the imm command. Here are the values I currently
+eeprom using the 'i2c mm' command. Here are the values I currently
use:
-=> imd 50 0 10
+=> i2c md 50 0 10
0000: 85 7d 42 06 07 80 11 00 00 00 00 00 00 00 00 00 .}B.............