doc: fix typos
Fix a few typos spot during a first read of the contribution process.
Signed-off-by: Maxim Cournoyer <maxim.cournoyer@savoirfairelinux.com>
Reviewed-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
diff --git a/doc/develop/system_configuration.rst b/doc/develop/system_configuration.rst
index 52e4e1d..40be46b 100644
--- a/doc/develop/system_configuration.rst
+++ b/doc/develop/system_configuration.rst
@@ -86,12 +86,12 @@
^^^^^^^^^^^^^^^^^^^^^^^^^^
While there are some cases where it should be fairly obvious where to use each
-mechanism, as for example a command would done via Kconfig, a new I2C driver
+mechanism, as for example a command would be done via Kconfig, a new I2C driver
should use Kconfig and be configured via driver model and a header of values
generated by an external tool should be ``CFG``, there will be cases where it's
less clear and one needs to take care when implementing it. In general,
configuration *options* should be done in Kconfig and configuration *settings*
-should done in driver model or ``CFG``. Let us discuss things to keep in mind
+should be done in driver model or ``CFG``. Let us discuss things to keep in mind
when picking the appropriate mechanism.
A thing to keep in mind is that we have a strong preference for using Kconfig as
@@ -122,7 +122,7 @@
constructed values, resulting in less clear code. Consider the example of a set
of register values for a memory controller. Defining this as a series of logical
ORs and shifts based on other defines is more clear than the Kconfig entry that
-set the calculated value alone.
+sets the calculated value alone.
When it has been determined that the practical solution is to utilize the
``CFG`` mechanism, the next decision is where to place these settings. It is