at91sam9260/9263: add back up for the rst(reset controller).
On the boards at91sam9260ek, at91sam9263ek and afed9260, the rstc register was
set to 0 after being set to 500 ms for the PHY reset.
Do backup the old reset length and restore it after the MACB initialisation.
Signed-off-by: Sedji Gaouaou <sedji.gaouaou@atmel.com>
Signed-off-by: Stelian Pop <stelian@popies.net>
diff --git a/board/afeb9260/afeb9260.c b/board/afeb9260/afeb9260.c
index a247663..94a65c2 100644
--- a/board/afeb9260/afeb9260.c
+++ b/board/afeb9260/afeb9260.c
@@ -81,6 +81,8 @@
#ifdef CONFIG_MACB
static void afeb9260_macb_hw_init(void)
{
+ unsigned long rstc;
+
/* Enable clock */
at91_sys_write(AT91_PMC_PCER, 1 << AT91SAM9260_ID_EMAC);
@@ -103,6 +105,8 @@
pin_to_mask(AT91_PIN_PA28),
pin_to_controller(AT91_PIN_PA0) + PIO_PUDR);
+ rstc = at91_sys_read(AT91_RSTC_MR) & AT91_RSTC_ERSTL;
+
/* Need to reset PHY -> 500ms reset */
at91_sys_write(AT91_RSTC_MR, AT91_RSTC_KEY |
AT91_RSTC_ERSTL | (0x0D << 8) |
@@ -115,7 +119,7 @@
/* Restore NRST value */
at91_sys_write(AT91_RSTC_MR, AT91_RSTC_KEY |
- AT91_RSTC_ERSTL | (0x0 << 8) |
+ (rstc) |
AT91_RSTC_URSTEN);
/* Re-enable pull-up */