diff --git a/arch/x86/dts/edison.dts b/arch/x86/dts/edison.dts
index 2c8cf6c..b3658b8 100644
--- a/arch/x86/dts/edison.dts
+++ b/arch/x86/dts/edison.dts
@@ -94,6 +94,12 @@
 	sdcard: mmc@ff3fa000 {
 		compatible = "intel,sdhci-tangier";
 		reg = <0xff3fa000 0x1000>;
+		/*
+		 * In the disconnected state of the SD Card Detection pin
+		 * the read value is always the same and inverted to what
+		 * we are expecting in the code.
+		 */
+		cd-inverted;
 	};
 
 	pmu: power@ff00b000 {
@@ -132,6 +138,17 @@
 		reg = <0xff0c0000 0x8000>;
 
 		/*
+		 * Disconnect SD card detection pin, so it won't affect
+		 * the reality on two different PCB designs where it's
+		 * using the opposite signaling: Edison/Arduino uses
+		 * Active Low, while SparkFun went with Active High.
+		 */
+		sd_cd@0 {
+			pad-offset = <37>;
+			mode-func = <3>;
+		};
+
+		/*
 		 * Initial configuration came from the firmware.
 		 * Which quite likely has been used in the phones, where I2C #8,
 		 * that is not part of Atom peripheral, is in use.