common/cmd_[i-z]* : Augment CONFIG_COMMANDS tests with defined(CONFIG_CMD_*).
This is a compatibility step that allows both the older form
and the new form to co-exist for a while until the older can
be removed entirely.
All transformations are of the form:
Before:
#if (CONFIG_COMMANDS & CFG_CMD_AUTOSCRIPT)
After:
#if (CONFIG_COMMANDS & CFG_CMD_AUTOSCRIPT) || defined(CONFIG_CMD_AUTOSCRIPT)
Signed-off-by: Jon Loeliger <jdl@freescale.com>
diff --git a/common/cmd_i2c.c b/common/cmd_i2c.c
index 755810d..b9d9d33 100644
--- a/common/cmd_i2c.c
+++ b/common/cmd_i2c.c
@@ -86,7 +86,7 @@
#include <i2c.h>
#include <asm/byteorder.h>
-#if (CONFIG_COMMANDS & CFG_CMD_I2C)
+#if (CONFIG_COMMANDS & CFG_CMD_I2C) || defined(CONFIG_CMD_I2C)
/* Display values from last command.
@@ -657,7 +657,7 @@
* The SDRAM command is separately configured because many
* (most?) embedded boards don't use SDRAM DIMMs.
*/
-#if (CONFIG_COMMANDS & CFG_CMD_SDRAM)
+#if (CONFIG_COMMANDS & CFG_CMD_SDRAM) || defined(CONFIG_CMD_SDRAM)
/*
* Syntax:
@@ -938,7 +938,7 @@
return do_i2c_probe(cmdtp, flag, --argc, ++argv);
if (!strncmp(argv[1], "lo", 2))
return do_i2c_loop(cmdtp, flag, --argc, ++argv);
-#if (CONFIG_COMMANDS & CFG_CMD_SDRAM)
+#if (CONFIG_COMMANDS & CFG_CMD_SDRAM) || defined(CONFIG_CMD_SDRAM)
if (!strncmp(argv[1], "sd", 2))
return do_sdram(cmdtp, flag, --argc, ++argv);
#endif /* CFG_CMD_SDRAM */
@@ -965,7 +965,7 @@
"i2c crc32 chip address[.0, .1, .2] count - compute CRC32 checksum\n"
"i2c probe - show devices on the I2C bus\n"
"i2c loop chip address[.0, .1, .2] [# of objects] - looping read of device\n"
-#if (CONFIG_COMMANDS & CFG_CMD_SDRAM)
+#if (CONFIG_COMMANDS & CFG_CMD_SDRAM) || defined(CONFIG_CMD_SDRAM)
"i2c sdram chip - print SDRAM configuration information\n"
#endif /* CFG_CMD_SDRAM */
);
@@ -1016,7 +1016,7 @@
" - loop, reading a set of addresses\n"
);
-#if (CONFIG_COMMANDS & CFG_CMD_SDRAM)
+#if (CONFIG_COMMANDS & CFG_CMD_SDRAM) || defined(CONFIG_CMD_SDRAM)
U_BOOT_CMD(
isdram, 2, 1, do_sdram,
"isdram - print SDRAM configuration information\n",