MIPS: Make CM GCR base configurable
Without adding a prompt for CONFIG_MIPS_CM_BASE, Kconfig doesn't allow
defconfigs to set it. Provide the prompt in order to allow for that.
Signed-off-by: Paul Burton <paul.burton@imgtec.com>
Signed-off-by: Daniel Schwierzeck <daniel.schwierzeck@gmail.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig
index c97ea41..77d1ac6 100644
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -221,6 +221,16 @@
Disable this, if the U-Boot image is booted from DRAM (e.g. by SPL).
In that case the image size will be reduced by 0x500 bytes.
+config MIPS_CM_BASE
+ hex "MIPS CM GCR Base Address"
+ depends on MIPS_CM
+ default 0x1fbf8000
+ help
+ The physical base address at which to map the MIPS Coherence Manager
+ Global Configuration Registers (GCRs). This should be set such that
+ the GCRs occupy a region of the physical address space which is
+ otherwise unused, or at minimum that software doesn't need to access.
+
endmenu
menu "OS boot interface"
@@ -393,15 +403,6 @@
wish U-Boot to configure it or make use of it to retrieve system
information such as cache configuration.
-config MIPS_CM_BASE
- hex
- default 0x1fbf8000
- help
- The physical base address at which to map the MIPS Coherence Manager
- Global Configuration Registers (GCRs). This should be set such that
- the GCRs occupy a region of the physical address space which is
- otherwise unused, or at minimum that software doesn't need to access.
-
endif
endmenu