configs: imx8mp_beacon: Enable PCIe NVMe drives
The baseboard supports and NVMe drives via the PCIe slot. This
requires a few extra config options to be enabled.
The NVMe can be enumerated with the following commands:
u-boot=> pci enum
PCIE-0: Link up (Gen1-x1, Bus0)
u-boot=> nvme scan
u-boot=> nvme info
Device 0: Vendor: 0x15b7 Rev: 20120022 Prod: 184960441105
Type: Hard Disk
Capacity: 122104.3 MB = 119.2 GB (250069680 x 512)
u-boot=>
Signed-off-by: Adam Ford <aford173@gmail.com>
Reviewed-by: Sumit Garg <sumit.garg@linaro.org>
diff --git a/configs/imx8mp_beacon_defconfig b/configs/imx8mp_beacon_defconfig
index 0ae8c96..fe1678d 100644
--- a/configs/imx8mp_beacon_defconfig
+++ b/configs/imx8mp_beacon_defconfig
@@ -15,6 +15,7 @@
CONFIG_DEFAULT_DEVICE_TREE="freescale/imx8mp-beacon-kit"
CONFIG_SPL_TEXT_BASE=0x920000
CONFIG_TARGET_IMX8MP_BEACON=y
+CONFIG_DM_RESET=y
CONFIG_SYS_MONITOR_LEN=524288
CONFIG_SPL_MMC=y
CONFIG_SPL_SERIAL=y
@@ -27,6 +28,7 @@
CONFIG_ARMV8_EA_EL3_FIRST=y
CONFIG_SPL_IMX_ROMAPI_LOADADDR=0x48000000
CONFIG_SYS_LOAD_ADDR=0x40480000
+CONFIG_PCI=y
# CONFIG_ANDROID_BOOT_IMAGE is not set
CONFIG_FIT=y
CONFIG_FIT_EXTERNAL_OFFSET=0x3000
@@ -65,6 +67,7 @@
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
+CONFIG_CMD_PCI=y
CONFIG_CMD_USB=y
CONFIG_CMD_USB_SDP=y
CONFIG_CMD_USB_MASS_STORAGE=y
@@ -118,8 +121,11 @@
CONFIG_FEC_MXC=y
CONFIG_RGMII=y
CONFIG_MII=y
+CONFIG_NVME_PCI=y
+CONFIG_PCIE_DW_IMX=y
CONFIG_PHY=y
CONFIG_PHY_IMX8MQ_USB=y
+CONFIG_PHY_IMX8M_PCIE=y
CONFIG_PINCTRL=y
CONFIG_SPL_PINCTRL=y
CONFIG_PINCTRL_IMX8M=y