mmc: fsl_esdhc: Add new config option for default fallback mode
Currently default fallback SDHC mode is 1-bit. Add new config option
CONFIG_SYS_FSL_ESDHC_DEFAULT_BUS_WIDTH to allow specifying default fallback
mode. This is useful e.g. for SPL builds which loads other parts from SD
card during boot process.
Signed-off-by: Pali Rohár <pali@kernel.org>
Reviewed-by: Jaehoon Chung <jh80.chung@samsung.com>
diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig
index c8f9709..5a87db6 100644
--- a/drivers/mmc/Kconfig
+++ b/drivers/mmc/Kconfig
@@ -839,6 +839,11 @@
For eSDHC, power supply is through peripheral circuit. 3.3V support is
common. Select this if 3.3V power supply not supported.
+config SYS_FSL_ESDHC_DEFAULT_BUS_WIDTH
+ int
+ depends on FSL_ESDHC
+ default 1
+
config FSL_ESDHC_IMX
bool "Freescale/NXP i.MX eSDHC controller support"
help