pmic: allow dump command for non contiguous register maps
Some PMICs (such as the DA9063) have non-contiguous register maps.
Attempting to read the non implemented registers returns an error
rather than a dummy value which causes 'pmic dump' to terminate
prematurely.
Fix this by allowing the PMIC driver to return -ENODATA for such
registers, which will then be displayed as '--' by pmic dump.
Use a single error code rather than any error code so that
we can distinguish between a hardware failure reading the PMIC
and a non implemented register known to the driver.
Signed-off-by: Martin Fuzzey <martin.fuzzey@flowbird.group>
diff --git a/cmd/pmic.c b/cmd/pmic.c
index e46d813..2400bfb 100644
--- a/cmd/pmic.c
+++ b/cmd/pmic.c
@@ -95,7 +95,7 @@
for (reg = 0; reg < pmic_reg_count(dev); reg++) {
ret = pmic_reg_read(dev, reg);
- if (ret < 0) {
+ if (ret < 0 && ret != -ENODATA) {
printf("Can't read register: %d\n", reg);
return failure(ret);
}
@@ -103,7 +103,15 @@
if (!(reg % 16))
printf("\n0x%02x: ", reg);
- printf(fmt, ret);
+ if (ret == -ENODATA) {
+ int i;
+
+ for (i = 0; i < priv->trans_len; i++)
+ puts("--");
+ puts(" ");
+ } else {
+ printf(fmt, ret);
+ }
}
printf("\n");