doc: starfive: use jh7110_common.rst
To avoid duplicate maintenance just include jh7110_common.rst to describe
the usage of the different boot sources.
Reviewed-by: E Shattow <e@freeshell.de>
Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
diff --git a/doc/board/starfive/pine64_star64.rst b/doc/board/starfive/pine64_star64.rst
index 1df4b68..d1752c4 100644
--- a/doc/board/starfive/pine64_star64.rst
+++ b/doc/board/starfive/pine64_star64.rst
@@ -55,19 +55,6 @@
or the configuration variable CONFIG_DEFAULT_FDT_FILE can be used to set to
provide a default value.
-Boot source selection
----------------------
-
-Boot mode is selected by an MSEL-DIP marked S1804 and GPIO_0 position adjacent
-to the 40pin GPIO header. ON/ONKE and number markings of the MSEL-DIP are
-misleading; Instead refer to the ``L`` (0) and ``H`` (1) silkscreen for
-accurate selection.
-
-+ (QSPI) Flash: 00
-+ SD: 01
-+ EMMC: 10
-+ UART: 11
-
Preparing the SD-Card
---------------------
@@ -109,10 +96,7 @@
sudo cp jh7110-starfive-visionfive-2.dtb /mnt/
sudo umount /mnt
-Booting
--------
-
-Once you plugin the sdcard and power up, you should see the U-Boot prompt.
+.. include:: jh7110_common.rst
Serial Number and MAC address issues
------------------------------------