include/linux/mtd/mtd.h

/*
 * $Id: mtd.h,v 1.61 2005/11/07 11:14:54 gleixner Exp $
 *
 * Copyright (C) 1999-2003 David Woodhouse <dwmw2@infradead.org> et al.
 *
 * Released under GPL
 */

#ifndef __MTD_MTD_H__
#define __MTD_MTD_H__

#include <linux/types.h>
#include <linux/mtd/mtd-abi.h>

#define MTD_CHAR_MAJOR 90
#define MTD_BLOCK_MAJOR 31
#define MAX_MTD_DEVICES 32

#define MTD_ERASE_PENDING	0x01
#define MTD_ERASING		0x02
#define MTD_ERASE_SUSPEND	0x04
#define MTD_ERASE_DONE          0x08
#define MTD_ERASE_FAILED        0x10

/*
 * Enumeration for NAND/OneNAND flash chip state
 */
enum {
	FL_READY,
	FL_READING,
	FL_WRITING,
	FL_ERASING,
	FL_SYNCING,
	FL_CACHEDPRG,
	FL_RESETING,
	FL_UNLOCKING,
	FL_LOCKING,
	FL_PM_SUSPENDED,
};

/* If the erase fails, fail_addr might indicate exactly which block failed.  If
   fail_addr = 0xffffffff, the failure was not at the device level or was not
   specific to any particular block. */
struct erase_info {
	struct mtd_info *mtd;
	u_int32_t addr;
	u_int32_t len;
	u_int32_t fail_addr;
	u_long time;
	u_long retries;
	u_int dev;
	u_int cell;
	void (*callback) (struct erase_info *self);
	u_long priv;
	u_char state;
	struct erase_info *next;
};

struct mtd_erase_region_info {
	u_int32_t offset;			/* At which this region starts, from the beginning of the MTD */
	u_int32_t erasesize;		/* For this region */
	u_int32_t numblocks;		/* Number of blocks of erasesize in this region */
	unsigned long *lockmap;		/* If keeping bitmap of locks */
};

/*
 * oob operation modes
 *
 * MTD_OOB_PLACE:	oob data are placed at the given offset
 * MTD_OOB_AUTO:	oob data are automatically placed at the free areas
 *			which are defined by the ecclayout
 * MTD_OOB_RAW:		mode to read raw data+oob in one chunk. The oob data
 *			is inserted into the data. Thats a raw image of the
 *			flash contents.
 */
typedef enum {
	MTD_OOB_PLACE,
	MTD_OOB_AUTO,
	MTD_OOB_RAW,
} mtd_oob_mode_t;

/**
 * struct mtd_oob_ops - oob operation operands
 * @mode:	operation mode
 *
 * @len:	number of data bytes to write/read
 *
 * @retlen:	number of data bytes written/read
 *
 * @ooblen:	number of oob bytes to write/read
 * @oobretlen:	number of oob bytes written/read
 * @ooboffs:	offset of oob data in the oob area (only relevant when
 *		mode = MTD_OOB_PLACE)
 * @datbuf:	data buffer - if NULL only oob data are read/written
 * @oobbuf:	oob data buffer
 *
 * Note, it is allowed to read more then one OOB area at one go, but not write.
 * The interface assumes that the OOB write requests program only one page's
 * OOB area.
 */
struct mtd_oob_ops {
	mtd_oob_mode_t	mode;
	size_t		len;
	size_t		retlen;
	size_t		ooblen;
	size_t		oobretlen;
	uint32_t	ooboffs;
	uint8_t		*datbuf;
	uint8_t		*oobbuf;
};

struct mtd_info {
	u_char type;
	u_int32_t flags;
	u_int32_t size;	 // Total size of the MTD

	/* "Major" erase size for the device. Naïve users may take this
	 * to be the only erase size available, or may use the more detailed
	 * information below if they desire
	 */
	u_int32_t erasesize;
	/* Minimal writable flash unit size. In case of NOR flash it is 1 (even
	 * though individual bits can be cleared), in case of NAND flash it is
	 * one NAND page (or half, or one-fourths of it), in case of ECC-ed NOR
	 * it is of ECC block size, etc. It is illegal to have writesize = 0.
	 * Any driver registering a struct mtd_info must ensure a writesize of
	 * 1 or larger.
	 */
	u_int32_t writesize;

	u_int32_t oobsize;   // Amount of OOB data per block (e.g. 16)
	u_int32_t oobavail;  // Available OOB bytes per block

	// Kernel-only stuff starts here.
	char *name;
	int index;

	/* ecc layout structure pointer - read only ! */
	struct nand_ecclayout *ecclayout;

	/* Data for variable erase regions. If numeraseregions is zero,
	 * it means that the whole device has erasesize as given above.
	 */
	int numeraseregions;
	struct mtd_erase_region_info *eraseregions;

	int (*erase) (struct mtd_info *mtd, struct erase_info *instr);

	/* This stuff for eXecute-In-Place */
	int (*point) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char **mtdbuf);

	/* We probably shouldn't allow XIP if the unpoint isn't a NULL */
	void (*unpoint) (struct mtd_info *mtd, u_char * addr, loff_t from, size_t len);


	int (*read) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char *buf);
	int (*write) (struct mtd_info *mtd, loff_t to, size_t len, size_t *retlen, const u_char *buf);

	int (*read_oob) (struct mtd_info *mtd, loff_t from,
			 struct mtd_oob_ops *ops);
	int (*write_oob) (struct mtd_info *mtd, loff_t to,
			 struct mtd_oob_ops *ops);

	/*
	 * Methods to access the protection register area, present in some
	 * flash devices. The user data is one time programmable but the
	 * factory data is read only.
	 */
	int (*get_fact_prot_info) (struct mtd_info *mtd, struct otp_info *buf, size_t len);
	int (*read_fact_prot_reg) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char *buf);
	int (*get_user_prot_info) (struct mtd_info *mtd, struct otp_info *buf, size_t len);
	int (*read_user_prot_reg) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char *buf);
	int (*write_user_prot_reg) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char *buf);
	int (*lock_user_prot_reg) (struct mtd_info *mtd, loff_t from, size_t len);

/* XXX U-BOOT XXX */
#if 0
	/* kvec-based read/write methods.
	   NB: The 'count' parameter is the number of _vectors_, each of
	   which contains an (ofs, len) tuple.
	*/
	int (*writev) (struct mtd_info *mtd, const struct kvec *vecs, unsigned long count, loff_t to, size_t *retlen);
#endif

	/* Sync */
	void (*sync) (struct mtd_info *mtd);

	/* Chip-supported device locking */
	int (*lock) (struct mtd_info *mtd, loff_t ofs, size_t len);
	int (*unlock) (struct mtd_info *mtd, loff_t ofs, size_t len);

	/* Power Management functions */
	int (*suspend) (struct mtd_info *mtd);
	void (*resume) (struct mtd_info *mtd);

	/* Bad block management functions */
	int (*block_isbad) (struct mtd_info *mtd, loff_t ofs);
	int (*block_markbad) (struct mtd_info *mtd, loff_t ofs);

/* XXX U-BOOT XXX */
#if 0
	struct notifier_block reboot_notifier;  /* default mode before reboot */
#endif

	/* ECC status information */
	struct mtd_ecc_stats ecc_stats;
	/* Subpage shift (NAND) */
	int subpage_sft;

	void *priv;

	struct module *owner;
	int usecount;

	/* If the driver is something smart, like UBI, it may need to maintain
	 * its own reference counting. The below functions are only for driver.
	 * The driver may register its callbacks. These callbacks are not
	 * supposed to be called by MTD users */
	int (*get_device) (struct mtd_info *mtd);
	void (*put_device) (struct mtd_info *mtd);
};


	/* Kernel-side ioctl definitions */

extern int add_mtd_device(struct mtd_info *mtd);
extern int del_mtd_device (struct mtd_info *mtd);

extern struct mtd_info *get_mtd_device(struct mtd_info *mtd, int num);
extern struct mtd_info *get_mtd_device_nm(const char *name);

extern void put_mtd_device(struct mtd_info *mtd);

/* XXX U-BOOT XXX */
#if 0
struct mtd_notifier {
	void (*add)(struct mtd_info *mtd);
	void (*remove)(struct mtd_info *mtd);
	struct list_head list;
};

extern void register_mtd_user (struct mtd_notifier *new);
extern int unregister_mtd_user (struct mtd_notifier *old);

int default_mtd_writev(struct mtd_info *mtd, const struct kvec *vecs,
		       unsigned long count, loff_t to, size_t *retlen);

int default_mtd_readv(struct mtd_info *mtd, struct kvec *vecs,
		      unsigned long count, loff_t from, size_t *retlen);
#endif

#ifdef CONFIG_MTD_PARTITIONS
void mtd_erase_callback(struct erase_info *instr);
#else
static inline void mtd_erase_callback(struct erase_info *instr)
{
	if (instr->callback)
		instr->callback(instr);
}
#endif

/*
 * Debugging macro and defines
 */
#define MTD_DEBUG_LEVEL0	(0)	/* Quiet   */
#define MTD_DEBUG_LEVEL1	(1)	/* Audible */
#define MTD_DEBUG_LEVEL2	(2)	/* Loud    */
#define MTD_DEBUG_LEVEL3	(3)	/* Noisy   */

#ifdef CONFIG_MTD_DEBUG
#define MTDDEBUG(n, args...)				\
	do {						\
		if (n <= CONFIG_MTD_DEBUG_VERBOSE)	\
			printk(KERN_INFO args);		\
	} while(0)
#else /* CONFIG_MTD_DEBUG */
#define MTDDEBUG(n, args...) do { } while(0)
#endif /* CONFIG_MTD_DEBUG */

#endif /* __MTD_MTD_H__ */