siemens: eeprom: simplify setup & read
Since we have boards using the driver model or not for i2c, use abstraction
function to probe the i2c, check the EEPROM and read from EEPROM.
Signed-off-by: Enrico Leto <enrico.leto@siemens.com>
diff --git a/board/siemens/common/board.c b/board/siemens/common/board.c
index 420c496..e412858 100644
--- a/board/siemens/common/board.c
+++ b/board/siemens/common/board.c
@@ -29,7 +29,6 @@
#include <asm/io.h>
#include <asm/emif.h>
#include <asm/gpio.h>
-#include <i2c.h>
#include <miiphy.h>
#include <cpsw.h>
#include <watchdog.h>
@@ -39,6 +38,7 @@
DECLARE_GLOBAL_DATA_PTR;
+
#ifdef CONFIG_SPL_BUILD
void set_uart_mux_conf(void)
{
@@ -49,12 +49,13 @@
{
/* Initalize the board header */
enable_i2c0_pin_mux();
- i2c_set_bus_num(0);
/* enable early the console */
gd->baudrate = CONFIG_BAUDRATE;
serial_init();
gd->have_console = 1;
+
+ siemens_ee_setup();
if (read_eeprom() < 0)
puts("Could not get board ID.\n");
@@ -79,8 +80,7 @@
#if defined(CONFIG_HW_WATCHDOG)
hw_watchdog_init();
#endif /* defined(CONFIG_HW_WATCHDOG) */
- i2c_set_bus_num(0);
- if (read_eeprom() < 0)
+ if (siemens_ee_setup() < 0)
puts("Could not get board ID.\n");
#ifdef CONFIG_MACH_TYPE
gd->bd->bi_arch_number = CONFIG_MACH_TYPE;