tree 145cbe641d32efcdfb5be8e25da6a68dda97dafc
parent 3bca8f54b90e1b3bdfc3b57cd05f5715c732e6e7
author Marek Vasut <marex@denx.de> 1527191920 +0200
committer Jagan Teki <jagan@amarulasolutions.com> 1528135297 +0530

sf: Set current flash bank to 0 in clean_bar()

The clean_bar() function resets the SPI NOR BAR register to 0, but
does not set the flash->curr_bar to 0 , therefore those two can get
out of sync, which could ultimatelly result in corrupted flash content.

The simplest test case is this:

  => mw 0x10000000 0x1234abcd 0x4000
  => sf probe
  => sf erase 0x1000000 0x10000
  => sf write 0x10000000 0x1000000 0x10000

  => sf probe ; sf read 0x12000000 0 0x10000 ; md 0x12000000

That is, erase a sector above the 16 MiB boundary and write it with
random pre-configured data. What will actually happen without this
patch is the sector will be erased, but the data will be written to
BAR 0 offset 0x0 in the flash.

This is because the erase command will call write_bar()+clean_bar(),
which will leave flash->bank_curr = 1 while the hardware BAR registers
will be set to 0 through clean_bar(). The subsequent write will also
trigger write_bar()+clean_bar(), but write_bar checks if the target
bank == flash->bank_curr and if so, does NOT reconfigure the BAR in
the SPI NOR. Since flash->bank_curr is still 1 and out of sync with
the HW, the condition matches, BAR programming is skipped and write
ends up at address 0x0, thus corrupting flash content.

Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Tom Rini <trini@konsulko.com>
Reviewed-by: Jagan Teki <jagan@openedev.com>