sunxi: Add option to prevent booting on power plug-in
For sunxi boards with the AXP209, AXP221, AXP809, and AXP818 PMICs
(plus possibly others, I only confirmed the datasheets for these),
it is sometimes desirable to not boot whenever the device is
plugged in. An example would be when using the NTC CHIP inside a
PocketCHIP.
This provides a configurable option to check if bit 0 of
register 0 of the PMIC says it was powered because of a power button
press (0) or a plug-in event (1). If the value is 1 and this option
is selected, the device shuts down shortly after printing a message
to console stating the reason why it's shutting down. Powering up the
board with the power button is not affected.
Signed-off-by: Chris Morgan <macromorgan@hotmail.com>
[Andre: reword to speak of boot, remove #ifdefs]
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
diff --git a/arch/arm/mach-sunxi/Kconfig b/arch/arm/mach-sunxi/Kconfig
index 2c18cf0..d7f9a03 100644
--- a/arch/arm/mach-sunxi/Kconfig
+++ b/arch/arm/mach-sunxi/Kconfig
@@ -785,6 +785,16 @@
---help---
Say Y here to enable support for the gpio pins of the axp PMIC ICs.
+config AXP_DISABLE_BOOT_ON_POWERON
+ bool "Disable device boot on power plug-in"
+ depends on AXP209_POWER || AXP221_POWER || AXP809_POWER || AXP818_POWER
+ default n
+ ---help---
+ Say Y here to prevent the device from booting up because of a plug-in
+ event. When set, the device will boot into the SPL briefly to
+ determine why it was powered on, and if it was determined because of
+ a plug-in event instead of a button press event it will shut back off.
+
config VIDEO_SUNXI
bool "Enable graphical uboot console on HDMI, LCD or VGA"
depends on !MACH_SUN8I_A83T