remove unnecessary code in ata_piix
We set sata_curr_device to 0 right after returning from init_sata(), so there's
no point in setting it to the last scanned driver at this point.
Note: there are more duplicities with cmd_sata, but those might be required,
as the code seems to reset the entire controller on every scan, ignoring the
requested port number.
Signed-off-by: Pavel Herrmann <morpheus.ibis@gmail.com>
diff --git a/drivers/block/ata_piix.c b/drivers/block/ata_piix.c
index c81d11a..1c3ab8a 100644
--- a/drivers/block/ata_piix.c
+++ b/drivers/block/ata_piix.c
@@ -204,9 +204,6 @@
dev_print (&sata_dev_desc[devno]);
/* initialize partition type */
init_part (&sata_dev_desc[devno]);
- if (sata_curr_device < 0)
- sata_curr_device =
- i * CONFIG_SYS_SATA_DEVS_PER_BUS + j;
}
}
}