sunxi: arm64: correct usage of DT node address in FIT generation
The DT spec demands a unit-address in a node name to match the "reg"
property in that node. Newer dtc versions will throw warnings if this is
not the case.
Adjust the FIT build script for 64-bit Allwinner boards to remove the
bogus addresses from the node names and avoid the warnings.
This avoids a warning with recent versions of the dtc tool.
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
diff --git a/board/sunxi/mksunxi_fit_atf.sh b/board/sunxi/mksunxi_fit_atf.sh
index b1d6e0e..36abe9e 100755
--- a/board/sunxi/mksunxi_fit_atf.sh
+++ b/board/sunxi/mksunxi_fit_atf.sh
@@ -21,7 +21,7 @@
#address-cells = <1>;
images {
- uboot@1 {
+ uboot {
description = "U-Boot (64-bit)";
data = /incbin/("u-boot-nodtb.bin");
type = "standalone";
@@ -29,7 +29,7 @@
compression = "none";
load = <0x4a000000>;
};
- atf@1 {
+ atf {
description = "ARM Trusted Firmware";
data = /incbin/("$BL31");
type = "firmware";
@@ -44,7 +44,7 @@
for dtname in $*
do
cat << __FDT_IMAGE_EOF
- fdt@$cnt {
+ fdt_$cnt {
description = "$(basename $dtname .dtb)";
data = /incbin/("$dtname");
type = "flat_dt";
@@ -57,7 +57,7 @@
cat << __CONF_HEADER_EOF
};
configurations {
- default = "config@1";
+ default = "config_1";
__CONF_HEADER_EOF
@@ -65,11 +65,11 @@
for dtname in $*
do
cat << __CONF_SECTION_EOF
- config@$cnt {
+ config_$cnt {
description = "$(basename $dtname .dtb)";
- firmware = "uboot@1";
- loadables = "atf@1";
- fdt = "fdt@$cnt";
+ firmware = "uboot";
+ loadables = "atf";
+ fdt = "fdt_$cnt";
};
__CONF_SECTION_EOF
cnt=$((cnt+1))