imx: imx6ul: disable POR_B internal pull up
>From TO1.1, SNVS adds internal pull up control for POR_B,
the register filed is GPBIT[1:0], after system boot up,
it can be set to 2b'01 to disable internal pull up.
It can save about 30uA power in SNVS mode.
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Cc: Stefano Babic <sbabic@denx.de>
diff --git a/arch/arm/cpu/armv7/mx6/soc.c b/arch/arm/cpu/armv7/mx6/soc.c
index 09f2b02..7b53bfd 100644
--- a/arch/arm/cpu/armv7/mx6/soc.c
+++ b/arch/arm/cpu/armv7/mx6/soc.c
@@ -362,14 +362,27 @@
set_ahb_rate(132000000);
}
- if (is_mx6ul() && is_soc_rev(CHIP_REV_1_0) == 0) {
- /*
- * According to the design team's requirement on i.MX6UL,
- * the PMIC_STBY_REQ PAD should be configured as open
- * drain 100K (0x0000b8a0).
- * Only exists on TO1.0
- */
- writel(0x0000b8a0, IOMUXC_BASE_ADDR + 0x29c);
+ if (is_mx6ul()) {
+ if (is_soc_rev(CHIP_REV_1_0) == 0) {
+ /*
+ * According to the design team's requirement on
+ * i.MX6UL,the PMIC_STBY_REQ PAD should be configured
+ * as open drain 100K (0x0000b8a0).
+ * Only exists on TO1.0
+ */
+ writel(0x0000b8a0, IOMUXC_BASE_ADDR + 0x29c);
+ } else {
+ /*
+ * From TO1.1, SNVS adds internal pull up control
+ * for POR_B, the register filed is GPBIT[1:0],
+ * after system boot up, it can be set to 2b'01
+ * to disable internal pull up.It can save about
+ * 30uA power in SNVS mode.
+ */
+ writel((readl(MX6UL_SNVS_LP_BASE_ADDR + 0x10) &
+ (~0x1400)) | 0x400,
+ MX6UL_SNVS_LP_BASE_ADDR + 0x10);
+ }
}
if (is_mx6ull()) {