sunxi: Switch to PMIC USB power supply VBUS detection
Update boards to use the USB power supply driver, as referenced in the
device tree, instead of a virtual GPIO. This removes the need for some
DM-incompatible special cases in the GPIO driver.
The following five boards used AXP0-VBUS-DETECT in their config, but are
missing the "usb0_vbus_power-supply" property in their device tree:
- Ainol_AW1_defconfig / sun7i-a20-ainol-aw1
- Cubieboard4_defconfig / sun9i-a80-cubieboard4
- Merrii_A80_Optimus_defconfig / sun9i-a80-optimus
- Yones_Toptech_BD1078_defconfig / sun7i-a20-yones-toptech-bd1078
- Yones_Toptech_BS1078_V2_defconfig /
sun6i-a31s-yones-toptech-bs1078-v2
None of those five boards have the MUSB controller (USB OTG) enabled in
their device trees, so this change should not break anything for them.
Additionally, the following board intentionally omits the property
because VBUS is always enabled:
- Nintendo_NES_Classic_Edition_defconfig /
sun8i-r16-nintendo-nes-classic
The PHY driver already assumes VBUS is enabled when no detection method
is available, so again this will not cause any problems.
Signed-off-by: Samuel Holland <samuel@sholland.org>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
diff --git a/configs/tbs_a711_defconfig b/configs/tbs_a711_defconfig
index b3c2e69..9a70b6b 100644
--- a/configs/tbs_a711_defconfig
+++ b/configs/tbs_a711_defconfig
@@ -9,11 +9,11 @@
CONFIG_DRAM_ODT_EN=y
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
-CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
CONFIG_USB0_ID_DET="PH11"
CONFIG_AXP_GPIO=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_FASTBOOT_CMD_OEM_FORMAT=y
+CONFIG_REGULATOR_AXP_USB_POWER=y
CONFIG_AXP_DCDC5_VOLT=1200
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_OHCI_HCD=y