pinctrl: Check pinconfig nodes pre-reloc status recursively
Pinconfig nodes normally bind recursively with PINCTRL_FULL and
PINCONF_RECURSIVE enabled. However, during U-Boot proper pre-relocation
any node marked with e.g. bootph-all will not bind unless its parent is
also marked for pre-reloc.
group1 {
pinconf1 {
bootph-all;
};
};
This cause the following warning message to be shown during U-Boot
proper pre-reloc stage on Rockchip devices, e.g on RK3568:
ns16550_serial serial@fe660000: pinctrl_select_state_full: uclass_get_device_by_phandle_id: err=-19
and on RK3328:
ns16550_serial serial@ff130000: pinctrl_select_state_full: uclass_get_device_by_phandle_id: err=-19
Check pinconfig nodes pre-reloc status recursively to fix this and to
make pinconfig_post_bind work same at both U-Boot proper pre-reloc and
at TPL/SPL stage.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Quentin Schulz <quentin.schulz@theobroma-systems.com>
diff --git a/drivers/pinctrl/pinctrl-uclass.c b/drivers/pinctrl/pinctrl-uclass.c
index 73dd7b1..fe2ba50 100644
--- a/drivers/pinctrl/pinctrl-uclass.c
+++ b/drivers/pinctrl/pinctrl-uclass.c
@@ -100,6 +100,22 @@
return 0;
}
+static bool ofnode_pre_reloc_recursive(ofnode parent)
+{
+ ofnode child;
+
+ if (ofnode_pre_reloc(parent))
+ return true;
+
+ if (CONFIG_IS_ENABLED(PINCONF_RECURSIVE)) {
+ ofnode_for_each_subnode(child, parent)
+ if (ofnode_pre_reloc_recursive(child))
+ return true;
+ }
+
+ return false;
+}
+
/**
* pinconfig_post_bind() - post binding for PINCONFIG uclass
* Recursively bind its children as pinconfig devices.
@@ -119,7 +135,7 @@
dev_for_each_subnode(node, dev) {
if (pre_reloc_only &&
- !ofnode_pre_reloc(node))
+ !ofnode_pre_reloc_recursive(node))
continue;
/*
* If this node has "compatible" property, this is not