/*
 * (C) Copyright 2007-2009 DENX Software Engineering
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */

#include <common.h>
#include <asm/bitops.h>
#include <command.h>
#include <asm/io.h>
#include <asm/processor.h>
#include <asm/mpc512x.h>
#include <fdt_support.h>
#ifdef CONFIG_MISC_INIT_R
#include <i2c.h>
#endif
#include <net.h>

#include <linux/mtd/mtd.h>
#include <linux/mtd/nand.h>

DECLARE_GLOBAL_DATA_PTR;

void __mpc5121_nfc_select_chip(struct mtd_info *mtd, int chip);

/* Active chip number set in board_nand_select_device() (mpc5121_nfc.c) */
extern int mpc5121_nfc_chip;

/* Control chips select signal on MPC5121ADS board */
void mpc5121_nfc_select_chip(struct mtd_info *mtd, int chip)
{
	unsigned char *csreg = (u8 *)CONFIG_SYS_CPLD_BASE + 0x09;
	u8 v;

	v = in_8(csreg);
	v |= 0x0F;

	if (chip >= 0) {
		__mpc5121_nfc_select_chip(mtd, 0);
		v &= ~(1 << mpc5121_nfc_chip);
	} else {
		__mpc5121_nfc_select_chip(mtd, -1);
	}

	out_8(csreg, v);
}

int board_early_init_f(void)
{
	/*
	 * Disable Boot NOR FLASH write protect - CPLD Reg 8 NOR FLASH Control
	 *
	 * Without this the flash identification routine fails, as it needs to issue
	 * write commands in order to establish the device ID.
	 */

#ifdef CONFIG_MPC5121ADS_REV2
	out_8((u8 *)(CONFIG_SYS_CPLD_BASE + 0x08), 0xC1);
#else
	if (in_8((u8 *)(CONFIG_SYS_CPLD_BASE + 0x08)) & 0x04) {
		out_8((u8 *)(CONFIG_SYS_CPLD_BASE + 0x08), 0xC1);
	} else {
		/* running from Backup flash */
		out_8((u8 *)(CONFIG_SYS_CPLD_BASE + 0x08), 0x32);
	}
#endif
	return 0;
}

int is_micron(void){

	ushort brd_rev = *(vu_short *)(CONFIG_SYS_CPLD_BASE + 0x00);
	uchar macaddr[6];
	u32 brddate, macchk, ismicron;

	/*
	 * MAC address has serial number with date of manufacture
	 * Boards made before Nov-08 #1180 use Micron memory;
	 * 001e59 is the STx vendor #
	 * Default is Elpida since it works for both but is slightly slower
	 */
	ismicron = 0;
	if (brd_rev >= 0x0400 && eth_getenv_enetaddr("ethaddr", macaddr)) {
		brddate = (macaddr[3] << 16) + (macaddr[4] << 8) + macaddr[5];
		macchk = (macaddr[0] << 16) + (macaddr[1] << 8) + macaddr[2];
		debug("brddate = %d\n\t", brddate);

		if (macchk == 0x001e59 && brddate <= 8111180)
			ismicron = 1;
	} else if (brd_rev < 0x400) {
		ismicron = 1;
	}
	debug("Using %s Memory settings\n\t",
		ismicron ? "Micron" : "Elpida");
	return(ismicron);
}

int dram_init(void)
{
	u32 msize = 0;
	/*
	 * Elpida MDDRC and initialization settings are an alternative
	 * to the Default Micron ones for all but the earliest Rev 4 boards
	 */
	ddr512x_config_t elpida_mddrc_config = {
		.ddr_sys_config   = CONFIG_SYS_MDDRC_SYS_CFG_ELPIDA,
		.ddr_time_config0 = CONFIG_SYS_MDDRC_TIME_CFG0,
		.ddr_time_config1 = CONFIG_SYS_MDDRC_TIME_CFG1_ELPIDA,
		.ddr_time_config2 = CONFIG_SYS_MDDRC_TIME_CFG2_ELPIDA,
	};

	u32 elpida_init_sequence[] = {
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_PCHG_ALL,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_RFSH,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_RFSH,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_EM2,
		CONFIG_SYS_DDRCMD_EM3,
		CONFIG_SYS_DDRCMD_EN_DLL,
		CONFIG_SYS_ELPIDA_RES_DLL,
		CONFIG_SYS_DDRCMD_PCHG_ALL,
		CONFIG_SYS_DDRCMD_RFSH,
		CONFIG_SYS_DDRCMD_RFSH,
		CONFIG_SYS_DDRCMD_RFSH,
		CONFIG_SYS_ELPIDA_INIT_DEV_OP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_OCD_DEFAULT,
		CONFIG_SYS_ELPIDA_OCD_EXIT,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP,
		CONFIG_SYS_DDRCMD_NOP
	};

	if (is_micron()) {
		msize = fixed_sdram(NULL, NULL, 0);
	} else {
		msize = fixed_sdram(&elpida_mddrc_config,
				elpida_init_sequence,
				sizeof(elpida_init_sequence)/sizeof(u32));
	}

	gd->ram_size = msize;

	return 0;
}

int misc_init_r(void)
{
	return 0;
}

static  iopin_t ioregs_init[] = {
	/* FUNC1=FEC_RX_DV Sets Next 3 to FEC pads */
	{
		offsetof(struct ioctrl512x, io_control_spdif_txclk), 3, 0,
		IO_PIN_FMUX(1) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(0) | IO_PIN_DS(3)
	},
	/* Set highest Slew on 9 PATA pins */
	{
		offsetof(struct ioctrl512x, io_control_pata_ce1), 9, 1,
		IO_PIN_FMUX(0) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(0) | IO_PIN_DS(3)
	},
	/* FUNC1=FEC_COL Sets Next 15 to FEC pads */
	{
		offsetof(struct ioctrl512x, io_control_psc0_0), 15, 0,
		IO_PIN_FMUX(1) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(0) | IO_PIN_DS(3)
	},
	/* FUNC1=SPDIF_TXCLK */
	{
		offsetof(struct ioctrl512x, io_control_lpc_cs1), 1, 0,
		IO_PIN_FMUX(1) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(1) | IO_PIN_DS(3)
	},
	/* FUNC2=SPDIF_TX and sets Next pin to SPDIF_RX */
	{
		offsetof(struct ioctrl512x, io_control_i2c1_scl), 2, 0,
		IO_PIN_FMUX(2) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(1) | IO_PIN_DS(3)
	},
	/* FUNC2=DIU CLK */
	{
		offsetof(struct ioctrl512x, io_control_psc6_0), 1, 0,
		IO_PIN_FMUX(2) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(1) | IO_PIN_DS(3)
	},
	/* FUNC2=DIU_HSYNC */
	{
		offsetof(struct ioctrl512x, io_control_psc6_1), 1, 0,
		IO_PIN_FMUX(2) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(0) | IO_PIN_DS(3)
	},
	/* FUNC2=DIUVSYNC Sets Next 26 to DIU Pads */
	{
		offsetof(struct ioctrl512x, io_control_psc6_4), 26, 0,
		IO_PIN_FMUX(2) | IO_PIN_HOLD(0) | IO_PIN_PUD(0) |
		IO_PIN_PUE(0) | IO_PIN_ST(0) | IO_PIN_DS(3)
	}
};

static  iopin_t rev2_silicon_pci_ioregs_init[] = {
	/* FUNC0=PCI Sets next 54 to PCI pads */
	{
		offsetof(struct ioctrl512x, io_control_pci_ad31), 54, 0,
		IO_PIN_FMUX(0) | IO_PIN_HOLD(0) | IO_PIN_DS(0)
	}
};

int checkboard (void)
{
	ushort brd_rev = *(vu_short *) (CONFIG_SYS_CPLD_BASE + 0x00);
	uchar cpld_rev = *(vu_char *) (CONFIG_SYS_CPLD_BASE + 0x02);
	volatile immap_t *im = (immap_t *) CONFIG_SYS_IMMR;
	u32 spridr = in_be32(&im->sysconf.spridr);

	printf ("Board: MPC5121ADS rev. 0x%04x (CPLD rev. 0x%02x)\n",
		brd_rev, cpld_rev);

	/* initialize function mux & slew rate IO inter alia on IO Pins  */
	iopin_initialize(ioregs_init, ARRAY_SIZE(ioregs_init));

	if (SVR_MJREV (spridr) >= 2)
		iopin_initialize(rev2_silicon_pci_ioregs_init, 1);

	return 0;
}

#ifdef CONFIG_OF_BOARD_SETUP
int ft_board_setup(void *blob, bd_t *bd)
{
	ft_cpu_setup(blob, bd);

	return 0;
}
#endif /* CONFIG_OF_BOARD_SETUP */