net: gem: Pass phy address to init
Pass the PHY address to the driver init to
allow parallel use of both interfaces
Signed-off-by: David Andrey <david.andrey@netmodule.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Reviewed-by: Tom Rini <trini@ti.com>
diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 2d717e9..316816d 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -427,7 +427,7 @@
return phywrite(dev, addr, reg, val);
}
-int zynq_gem_initialize(bd_t *bis, int base_addr)
+int zynq_gem_initialize(bd_t *bis, int base_addr, int phy_addr)
{
struct eth_device *dev;
struct zynq_gem_priv *priv;
@@ -443,11 +443,7 @@
}
priv = dev->priv;
-#ifdef CONFIG_PHY_ADDR
- priv->phyaddr = CONFIG_PHY_ADDR;
-#else
- priv->phyaddr = -1;
-#endif
+ priv->phyaddr = phy_addr;
sprintf(dev->name, "Gem.%x", base_addr);