net: dm: fec: Fix phy-reset-duration clamping and defaults
The DT binding says:
- phy-reset-duration : Reset duration in milliseconds. Should present
only if property "phy-reset-gpios" is available. Missing the property
will have the duration be 1 millisecond. Numbers greater than 1000 are
invalid and 1 millisecond will be used instead.
However the current code:
- clamps values greater than 1000ms to 1000ms rather than 1.
- does not initialize the delay if the property does not exist
(else clause mismatch)
- returns an error if phy-reset-gpios is not defined
Fix all this and simplify by using dev_read_u32_default()
Signed-off-by: Martin Fuzzey <martin.fuzzey@flowbird.group>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
index a1295fc..da970ef 100644
--- a/drivers/net/fec_mxc.c
+++ b/drivers/net/fec_mxc.c
@@ -1352,22 +1352,19 @@
#ifdef CONFIG_DM_GPIO
ret = gpio_request_by_name(dev, "phy-reset-gpios", 0,
- &priv->phy_reset_gpio, GPIOD_IS_OUT);
- if (ret == 0) {
- ret = dev_read_u32_array(dev, "phy-reset-duration",
- &priv->reset_delay, 1);
- } else if (ret == -ENOENT) {
- priv->reset_delay = 1000;
- ret = 0;
- }
+ &priv->phy_reset_gpio, GPIOD_IS_OUT);
+ if (ret < 0)
+ return 0; /* property is optional, don't return error! */
+ priv->reset_delay = dev_read_u32_default(dev, "phy-reset-duration", 1);
if (priv->reset_delay > 1000) {
- printf("FEX MXC: gpio reset timeout should be less the 1000\n");
- priv->reset_delay = 1000;
+ printf("FEC MXC: phy reset duration should be <= 1000ms\n");
+ /* property value wrong, use default value */
+ priv->reset_delay = 1;
}
#endif
- return ret;
+ return 0;
}
static const struct udevice_id fecmxc_ids[] = {