spi: Update speed/mode on change
The spi_get_bus_and_cs() may be called on the same bus and chipselect
with different frequency or mode. This is valid usecase, but the code
fails to notify the controller of such a configuration change. Call
spi_set_speed_mode() in case bus frequency or bus mode changed to let
the controller update the configuration.
The problem can easily be triggered using the sspi command:
=> sspi 0:0@1000
=> sspi 0:0@2000
Without this patch, both transfers happen at 1000 Hz. With this patch,
the later transfer happens correctly at 2000 Hz.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Jagan Teki <jagan@amarulasolutions.com>
Cc: Patrick Delaunay <patrick.delaunay@foss.st.com>
diff --git a/drivers/spi/spi-uclass.c b/drivers/spi/spi-uclass.c
index ee30110..d867b27 100644
--- a/drivers/spi/spi-uclass.c
+++ b/drivers/spi/spi-uclass.c
@@ -391,6 +391,8 @@
} else if (ret) {
dev_err(bus, "Invalid chip select %d:%d (err=%d)\n", busnum, cs, ret);
return ret;
+ } else if (dev) {
+ plat = dev_get_parent_plat(dev);
}
if (!device_active(dev)) {
@@ -416,12 +418,22 @@
goto err;
}
+ /* In case bus frequency or mode changed, update it. */
+ if ((speed && bus_data->speed && bus_data->speed != speed) ||
+ (plat && plat->mode != mode)) {
+ ret = spi_set_speed_mode(bus, speed, mode);
+ if (ret)
+ goto err_speed_mode;
+ }
+
*busp = bus;
*devp = slave;
log_debug("%s: bus=%p, slave=%p\n", __func__, bus, *devp);
return 0;
+err_speed_mode:
+ spi_release_bus(slave);
err:
log_debug("%s: Error path, created=%d, device '%s'\n", __func__,
created, dev->name);